Howto:How to IPxx13

From innovaphone wiki
Jump to navigation Jump to search

Applies to

  • IP0013
  • IP6013
  • V13+

Brief

IP0013

  • VoIP-PBX and routing gateway including reverse proxy and SBC functionalities
  • Orderno.: 01-00013-001

IP6013

  • VoIP-PBX and routing gateway for four ISDN-S2M interfaces plus Reverse Proxy and SBC functionalities
  • Orderno.: 01-06013-001

SSD

IPxx13 owns two internal slots for M.2 SSD.

Slot interface is NVMe - non volatile memory express.

Slot formfactor is M.2 2242 M-Key - dimensioning 22mm*42mm.

Maximum power consumption per M.2 SSD is 2.5W.

SSD has to be plugged in outer slot SSD0. Use of secondary inner slot SSD1 is not supported.

innovaphone offers and supports M.2 SSD 512 GB with order no 03-00010-017.

Technical support in terms of investigation for other SSDs is not forseen.


Note: These information DO NOT APPLY to IPxx11 and IP11xx based SSDs! For information to those devices, refer to this article.

Power supply

The devices mandatorily require Power over Ethernet+ supply according to IEEE 802.3at, Class 4 (PoE+) for operation.

Firmware

Available in official release store

IP0013

Following firmware versions are available for the IP0013 gateway itself:

  • V13r2: available via release store since V13r2sr10, build no 136337

IP6013

Following firmware versions are available for the IP6013 gateway itself:

  • V13r1: available via release store since V13r1sr25, build no 132894
  • V13r2: starting with 13r2final, build no 136094

Application Platform

The device hosts an 64-bit-ARM-processor which requires use of 64bit-architecture application platform.

Respective arm64-AP is available for 13r1 and 13r2 in offical release store.

Use cases

IP0013 and IP6013 host 150 software conference channels for audio conferencing (since 13r3sr4, before 60).

IP6013 additionally hosts 60 hardware digital signal processors for support of PCM traffic via PRI interfaces, audio faxes and audio conferencing.

Cumulating hardware and software conference channels at IP6013 into a single room is not supported.

Use of features such as PBX-operation, PRI- and fax traffic, audio/video conferencing and Application Sharing influence the CPU load.

Exceeding the maximum CPU limit may lead to device outage.

innovaphone supports following use cases:

All-in-one-box

  • operation of PBX-functionality
  • IP0013: for conferencing use SCNF interface
  • IP6013: use HW-DSPs for PCM-Audio and Fax only, for conferencing use CONF or SCNF interface only

Gateway only

  • operation as gateway only without activated PBX functionality and no AP installed
  • IP0013: use SCNF for conferencing
  • IP6013: use PRI-interfaces and HW-DSPs for S2M-Audio and Fax and SCNF for conferencing,
    or in case of no PRI/FAX traffic, both CONF and SCNF can be used for conferencing

Herefore mentioned basic conditions apply at any time for all kind of configurations and usecases.

Known Issues

  • IP6013: FAX interface will provide audio-fax capabilities starting with 13r1sr26