From innovaphone-wiki

Jump to: navigation, search

All users configured. If LDAP replication with the innovaphone PBX was established, the DECT users configured in the PBX are also displayed here. It is possible to display individual, several or all users. To display a particular user, you must enter the user’s name (Long Name) in the field and then click show. You can also display several users by entering only the first letter of a user’s name in the field and then clicking show. Clicking show without entering a character string or letter displays all created users.

The display of the user data is organized in columns:

  • Long Name: "Long Name" defined in the PBX
  • Name: "Name" defined in the PBX
  • No: Call number registered in the PBX
  • Fty: Facilities for the endpoint like call forwarding
  • Display: Assigned display
  • IPEI: 12-digit IPEI number. You must click on the IPEI to enable DECT subscription for this User and IPEI for 120 seconds, if "With Activation" subscription mode is activated at Reference10:DECT/Config/System.
  • AC: It is possible to assign an access code (AC) to a user when setting up the user in the innovaphone PBX. If this was done, the access code is displayed here. See also the chapter titled "Reference9:DECT2/Config/System".
  • Prod: product number of the handset if available
  • SW: software version of the handset if available
  • Registration: The current registration state. Possible states: subscribing, pending or IP address of the VoIP device, with which the user has registered.

To add a new user, you must click the new link next to the tabular display of the existing users.


For a succesfull registration to the PBX, it's mandatory that at least one entry with the Name value exists in the Device Section of the PBX User.


Personal tools