Howto:Adjusting volume parameters on IP111 and IP112

From innovaphone wiki
Jump to navigation Jump to search

Applies To

  • IP111 or IP112 with V11r1 and above

Tweaking internal gains in the audio processing chain of the IP111 and IP112 is considered harmful because it assumes a fixed implementation. But the implementation cannot be kept static and may need changes at any time. Therefore support for these parameters is ceased. Please open a support ticket if your environment needs special audio considerations.

Disclaimer

To avoid hearing damage, please handle the values given below with care!
Increase any changes step by step only.
innovaphone accepts no liability for improper use of the settings listed here!

Adjusting the headset microphone gain

Different behaviours had been encountered for the microphone sensitivity of USB headsets that may need gain adjustment in the IP112 settings. Therefore a same Web page has been added on IP112 than on IP222 with version 12r2 SR11 and 12r1 SR19. Now it's possible to offset up or down the volume individually within the phone configuration. The value is an offset, which means that 0 is not off, it's the default value of the firmware.

The headset sensitivity can be adjusted with

  http://addr/dsp.xml

-> Volume

On the browser prompt, the same can be achieved via command

config add AC-DSP0 HEADSET /mic-volume

The default is restored by a corresponding

config rem AC-DSP0 ...

command.

Example to offset down the microphone sensitivity a bit:

  http://ip-adress-of-the-phone/!config add AC-DSP0 HEADSET /mic-volume -6
  http://ip-adress-of-the-phone/!config activate

Example to offset down the microphone sensitivity a bit more:

  http://ip-adress-of-the-phone/!config add AC-DSP0 HEADSET /mic-volume -12
  http://ip-adress-of-the-phone/!config activate

You hear the difference after the !config activate
Valid values are between -18 and +18, out of range values will be converted to the higher limit.

Example to restore default behaviour:

  http://ip-adress-of-the-phone/!config rem AC-DSP0 HEADSET /mic-volume 
  http://ip-adress-of-the-phone/!config activate

If you are satisfied with the settings, type:

  http://ip-adress-of-the-phone/!config write

Now, the values are in the config.

Note: the same adjustment is available for the handset microphone in case a headset has been plugged that replaces the handset.

Related Articles

Howto:Adjust Speaker volume on IP241 IP222 IP232

Howto:How to adjust the volume parameters on IP110, IP200A and IP230 in Version 6 Firmware

Howto:Adjusting_the_volume_parameters_on_IP200A,_IP110,_IP230_and_IP150_in_Version_6_and_later_Firmware