Howto:ES - LCRcom - Voz IP SIP-Provider (2017)

From innovaphone-wiki

(Difference between revisions)
Jump to: navigation, search

She (Talk | contribs)
(New page: == Summary == {{Template:SIP_TEST_STATUS_ongoing|update=June 20th, 2017|url=|productname=Voz_IP|providername=LCRcom}} <internal>Provider SBC: ENSR3.0.67.5-IS4-RMRG1656-RG803-CPI1-CPO6271<...)
Next diff →

Revision as of 14:40, 21 June 2017

Contents

Summary

PRELIMINARY REPORT -- Tests for this product are still ongoing (last updated June 20th, 2017) and may (and probably will) change.


List of Issues found in media-relay Configuration

CLNS 
Outgoing calls cannot be sent with a foreign calling party number (CLI).
Our tests of this feature have shown unstable results (that is, the feature sometimes worked and sometimes did not). This may for example be caused by different equipment used at the provider side (e.g. media gateways) which behave differently.
FAX T38 ONNET 
The provider does not support T.38 fax for onnet calls.
FAX T38 
The provider does not fully support T.38 fax He offers T38 but our tests were not reliable.
FAX T38ANDAUDIO 
The provider does not support fallback to audio-fax if T.38 fails.
SIP INFO 
The provider does not support conveying DTMF using the SIP-INFO method.

Here is the list of test-cases that have been performed for this provider: 180_RINGING, BASIC_CALL, CLIR, CLNS_ONNET, CLNS, CONN_NR_DIFF, CONN_NR_INCOMING, CONN_NR, DTMF, EARLY_MEDIA_INBOUND, FAX_AUDIO, FAX_T38_ONNET, FAX_T38, FAX_T38ANDAUDIO, G711A_ONNET, G711A, G711U_ONNET, G711U, G722_ONNET, G722, G729_ONNET, G729, HOLD_RETRIEVE, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, MOBILITY, OPUS_NB, OPUS_WB, RALERT_DISC, REDIR_302, REDIR_DIVHDR, REDIR_HISTHDR, REVERSE_MEDIA, SIP_INFO, SRTP_INCOMING, SRTP_INTERNAL, SRTP_OUTGOING, SUBSCRIBER_NR, XFER_BLIND, XFER_CONS_EXT, XFER_CONS_ALERT, XFER_CONS


Test Results

This SIP provider requires a media-relay configuration. That is, all media traffic between the SIP provider and all endpoints must flow through the SBC. For this reason, a configuration without media-relay has not been tested and hence no test results for this configuration are listed.

Configuration with media-relay

Registration 
The provider supports UDP and TCP as transport protocol. The tests were completed using TCP, since UDP is an unreliable protocol and requires all involved network elements to support IP-fragmentation.
NAT Traversal 
The provider cannot handle calls to clients behind NAT. Clients are required to use NAT-traversal methods like STUN. Drawback of this solution is that STUN doesn't work for all NAT routers (i.e. routers doing symmetric NAT). Because of this limitation, it depends on the customer network equipment whether the SIP-trunk is usable or not. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.
DTMF (RFC2833) 
The provider can convey DTMF digits using the RTP payload method as per RFC2833.
Session Timer 
The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
Redundancy 
Registration of two SIP-interfaces on the same SIP-account is not supported by the provider. As a result, you cannot have a Standby gateway/PBX using the same account for failover or load-balancing purposes.
Correct signalling of Ringing-state 
OK
CLIR 
OK
Clip No Screening (CLNS) 
CLIP no screening (CLNS) is not possible, that is, outgoing calls can only have the own subscriber number (or extension), no foreign numbers as calling line id. This affects for example externally forwarded and mobility calls. However, on-net (that is, from SIP provider to another customer at the same SIP provider) CLIP no screening (CLNS) is possible. As this is a non-German provider, the issue with off-net CLNS could be related to the provider or related to the international PSTN peering. Please consult the SIP provider if CLNS will work for you. Call redirection using the SIP 302 Redirect header is supported by the provider. Rerouting can be enabled by setting the Reroute supported check-mark in the corresponding Trunk object configuration. Also, the Interworking check-mark must be set in the route used for calls from and to the SIP provider.
However, during our test other interop problems were discovered when the Interworking Flag is enabled. Therefore it is not recommended to use the call redirection via SIP 302 Redirect header.
COLP 
Outbound and inbound calls to/from the PSTN show the correct connected number.
For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
Early-Media 
The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
Fax 
Transport of faxes to/from the PSTN via G.711 codec was tested successfully.
Transport of faxes using T.38 failed to PSTN and onnet destinations. Moreover fallback to audio-fax failed also.
As a result, T.38 is disabled on the SIP-interface and the use of audio-fax is necessary.
Codecs 
supported to/from PSTN: G711A, G711U and G729
supported onnet (VoIP to VoIP): G711A, G711U and G729
IP-Fragmentation 
OK
Large SIP messages 
OK
Reverse Media Negotiation 
OK
Mobility Calls 
Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.
SRTP 
The provider does not support audio encryption using SRTP.
Provider supports dialling subscriber numbers 
OK
Call Transfer 
OK


Configuration

Use profile ES-LCRcom-Voz_IP in Gateway/Interfaces/SIP to configure this SIP provider.

A most recent v12r2 firmware is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2

New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.

Disclaimer

These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.

All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.

If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.

Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.

Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.

Personal tools