Howto:FR - OpenIP - SIP Trunk Touch SIP-Provider (2019)

From innovaphone-wiki

Jump to: navigation, search

Contents

Summary

PRELIMINARY REPORT -- Tests for this product are still ongoing (last updated January 17th, 2019) and may (and probably will) change.

Remarks

This provider use custom value of Identity header. May you should change the automated "add UUI" configuraiton in route map.

The UUI should be a SIP URI with a valid number present on your trunk.

See detail on wiki: How_to_customize_the_From/Identity_header_value_at_SIP_interfaces

List of Issues found in media-relay Configuration

CLNS ONNET 
Onnet-Calls (that is, within the provider's network) do not allow foreign calling party numbers (CGPN). In other words, clip no screening is not possible for on-net calls.
CLNS 
Outgoing calls cannot be sent with a foreign calling party number (CLI).
FAX T38 
The provider does not fully support T.38 fax
FAX T38ANDAUDIO 
The provider does not support fallback to audio-fax if T.38 fails.
RALERT DISC 
Call disconnected by far end during alert does not disconnect locally
REDIR 302 
The provider does not support external call redirection using the SIP 302 Redirect response
REVERSE MEDIA 
The provider does not support reverse media negotiation (a.k.a. late SDP)
SIP INFO 
The provider does not support conveying DTMF using the SIP-INFO method.
XFER BLIND 
The provider does not fully support blind call transfer scenarios.
XFER CONS ALERT 
The provider does not fully support consultation call transfer after alert scenarios.
XFER CONS EXT 
The provider does not fully support external consultation call transfer scenarios.
XFER CONS 
The provider does not fully support consultation call transfer after connect scenarios.

Here is the list of test-cases that have been performed for this provider: SUBSCRIBER_NR, 180_RINGING, BASIC_CALL, CLIR, CLNS_ONNET, CLNS, CONN_NR_DIFF, CONN_NR_INCOMING, CONN_NR, DTMF, EARLY_MEDIA_INBOUND, FAX_AUDIO, FAX_T38_ONNET, FAX_T38, FAX_T38ANDAUDIO, G711A_ONNET, G711A, G711U_ONNET, G711U, G722_ONNET, G722, G729_ONNET, G729, HOLD_RETRIEVE, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, MOBILITY, OPUS_NB, OPUS_WB, RALERT_DISC, REDIR_302, REDIR_DIVHDR, REDIR_HISTHDR, REVERSE_MEDIA, SDP_ICE, SDP_RTCP_MUX, SDP_VIDEO, SIP_INFO, SRTP_INCOMING, SRTP_INTERNAL, SRTP_OUTGOING, XFER_BLIND, XFER_CONS_ALERT, XFER_CONS_EXT, XFER_CONS


Test Results

This SIP provider requires a media-relay configuration. That is, all media traffic between the SIP provider and all endpoints must flow through the SBC. For this reason, a configuration without media-relay has not been tested and hence no test results for this configuration are listed.

Configuration with media-relay

Registration 
The provider supports only UDP as transport protocol. As a result, the SIP-communication is not encrypted(TLS). Moreover it requires all involved network elements to support IP-fragmentation.
NAT Traversal 
The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.
DTMF (RFC2833) 
The provider can convey DTMF digits using the RTP payload method as per RFC2833.
Session Timer 
The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
Redundancy 
Registration of two SIP-interfaces on the same SIP-account is supported by the provider. However, the provider has no failover mechanism if one device is down. As a result, you can use both SIP-interfaces for load-balancing purposes. If one device is down, for 2 minutes incoming and outgoing calls might be rejected/fail.
Dialing of Subscriber Numbers 
The provider does not support dialling numbers in subscriber number format. Make sure to configure the Dialing Location accordingly.
Correct signalling of Ringing-state 
OK
An outgoing call that is disconnected by the far end during alert is not disconnected locally. Typically, the provider may play a message to the effect that the call has been rejected or the call can not be completed so that the calling user will hang up. This may be OK, however, it may create issues with automated calls (e.g. fax or modem) which do not listen to the announcement and keep waiting for the far end to accept the call.
CLIR 
OK
Clip No Screening (CLNS) 
CLIP no screening (CLNS) is not possible, that is, outgoing calls can only have the own subscriber number (or extension), no foreign numbers as calling line id. This affects for example externally forwarded and mobility calls.
COLP 
Outbound and inbound calls to/from the PSTN show the correct connected number.
For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
Early-Media 
The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
Fax 
Transport of faxes to/from the PSTN via G.711 codec was tested successfully.
Transport of faxes using T.38 worked to onnet destinations. However it failed to PSTN destination and moreover fallback to audiofax failed also.
As a result, T.38 is disabled on the SIP-interface and the use of audio-fax is necessary.
Codecs 
supported to/from PSTN: G711A, G711U and G729
supported onnet (VoIP to VoIP): G711A, G711U, G722 and G729
IP-Fragmentation 
OK
Large SIP messages 
OK
Reverse Media Negotiation 
Reverse-media negotiation is not supported. Therefore, a media-relay with exclusive coder configuration will be activated on the SIP-interface.
Mobility Calls 
Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.
SRTP 
The provider does not support audio encryption using SRTP.
Call Transfer 
The provider does not handle internally transferred-after-connect calls.
The provider does not handle internally transferred-after-alert calls.
The provider does not handle internally blind-transferred calls.
The provider does not handle externally transferred calls.


Configuration

Use profile FR-OpenIP-SIP_Trunk_Touch in Gateway/Interfaces/SIP to configure this SIP provider.

A most recent v12r2 firmware is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2

New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.

Disclaimer

These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.

All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.

If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.

Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.

Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.

Personal tools