Howto:GlobalConnect SIP-Trunk - SIP Provider Compatibility Test

From innovaphone wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

Innovaphone Compatibility Test Report

Summary

GlobalConnect

The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.

The provider doesn't support Redundancy scenarios with multiple SIP-trunks(master & standby) registered at one account.

The provider also doesn't support T.38 Transcoding. Globalconnect offers International Fixed-line numbers for more than 30 countries in and outside Europe.

That being said, the provider has achieved 96% of all possible test points (150/157). For more information on the test rating, please refer to Test Description

  • Features:
    • DTMF
  • Supported Codecs by the provider
    • G711
    • G729
    • G722
    • G723
    • T.38

Current test state

Recprod.PNG The tests for this product have been completed and it has been approved as a recommended product (Certification document).

Testing of this product has been finalized September 2nd, 2014.

Testing Enviroment

SIPProviderTestTopology1.PNG

This scenario describes a setup where the PBX and phones are in a private network.

The SIP trunk is configured without Media Relay and without exclusive coder.

Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

Basic Call

Tested feature Result
call using g711a Ok
call using g711u Ok
call using g723 Ok, if remote end is at same provider and also supports G723
call using g729 Ok
call using g722 Ok, if remote end is at same provider and also supports G722
Overlapped sending Nok
early media channel Ok
Fax using T.38 Ok
T.38 Transcoding by the provider Nok
Reverse Media Negotiation Ok
CGPN can be suppressed Ok
CLIP no screening Ok
Long time call possible(>30 min) Ok
External Transfer Ok
NAT Detection Ok
Redundancy Nok
SIP over TCP Ok
Voice Quality OK? Ok

Direct Dial In

Tested feature Result
Inbound(Provider -> Innovaphone) Ok
Outbound(Innovaphone -> Provider) Ok
Loop In call(Innovaphone -> Provider -> Innovaphone) Ok

DTMF

Tested feature Result
DTMF tones sent correctly Ok
DTMF tones sent correctly via SIP-Info Nok
DTMF tones received correctly Ok

Hold/Retrieve

Tested feature Result
Call can be put on hold Ok
Held end hears music on hold / announcement from PBX Ok

Transfer with consultation

Tested feature Result
Call can be transferred Ok
Held end hears music on hold Ok

The following tests are made to test if call transfer is working.

Tested feature Voice Ok? MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone. Ok Ok
inno1 calls PSTN-phone. inno1 transfers to inno2. Ok Ok
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. Ok Ok
PSTN-phone calls inno1. inno1 transfers to inno2. Ok Ok
PSTN-phone calls inno1. PSTN-phone transfers to inno2. Ok Ok
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. Ok Ok

Transfer with consultation (alerting only)

Tested feature Result
Call can be transferred Ok
Held end hears music on hold or dialling tone Ok
Call returns to transferring device if the third

Endpoint is not available

Ok

The following tests are made to test if call transfer is working.

Tested feature Voice Ok? MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone. Ok Ok
inno1 calls PSTN-phone. inno1 transfers to inno2. Ok Ok
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. Ok Ok
PSTN-phone calls inno1. inno1 transfers to inno2. Ok Ok
PSTN-phone calls inno1. PSTN-phone transfers to inno2. Ok Ok
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. Ok Ok

Blind Transfer

Tested feature Result
Call can be transferred Ok
Held end hears dialling tone Ok

The following tests are made to test if call transfer is working.

Tested feature Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone. Ok
inno1 calls PSTN-phone. inno1 transfers to inno2. Ok
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. Ok
PSTN-phone calls inno1. inno1 transfers to inno2. Ok
PSTN-phone calls inno1. PSTN-phone transfers to inno2. Ok
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. Ok

CFU / CFB Transfer

Tested feature Result
Call can be forwarded Ok
Held end hears dialling tone Ok

CFNR / Blind Transfer (alerting only)

Tested feature Result
Call can be transferred or forwarded Ok
Held end hears dialling tone Ok

The following tests are made to test if call transfer is working.

Tested feature Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone. Ok
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. Ok
PSTN-phone calls inno1. inno1 transfers to inno2. Ok
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. Ok

Broadcast Group & Waiting Queue

Tested feature Result
Caller can make a call to a Broadcast Group Ok
Caller can make a call to a Waiting Queue Ok
Announcement if nobody picks up the call Ok

Configuration

Firmware version

All innovaphone devices use V10 SR12 as firmware.

SIP - Trunk

GlobalConnect SIP-Trunk - SIP Provider Compatibility Test 1.png

A SIP interface can be used to connect to the provider. Make sure to configure the SIP Interop Tweaks as in the screenshot above. MediaRelay is not needed.

Number Mapping

GlobalConnect SIP-Trunk - SIP Provider Compatibility Test 2.png

The provider will send and receive all numbers (CGPN & CDPN) in international number format.

Route Settings

GlobalConnect SIP-Trunk - SIP Provider Compatibility Test 3.png

The provider does not support overlap dialling, so Force Enblock must be activated in the route from RS1 to SIP1.

Since Clip No Screening is supported, make sure to have a route mapping that adjust calls with numbers other than the own trunknumber to a proper format. (see screenshot comment Clip No Screening)

Known Problems

  • In order for CLIP No Screening to work, we must configure the use of the P-Asserted Identity as shown below.
http://x.x.x.x/!config add SIP /pai
http://x.x.x.x/!config write
http://x.x.x.x/!config activate