Howto:Hafslund SIP Trunk - Hafslund - SIP Testreport

From innovaphone wiki
Revision as of 16:20, 18 June 2008 by Sga (talk | contribs) (New page: '''Innovaphone Compatibility Test Report''' == Summary == '''SIP Provider: Hafslund''' <!-- The provider supports all required innovaphone features and is therefore qualified as [[Howto:...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

Innovaphone Compatibility Test Report

Summary

SIP Provider: Hafslund

  • Features:
    • Direct Dial In
    • Fax over IP (T.38)
    • DTMF
  • Supported Codecs by the provider
    • G711A
    • G729
    • T.38 UDP

Current test state

The tests for this product have been completed.

Testing of this product has been finalized June 17th, 2008.

Testing Enviroment

Scenario NAT

HFO SIP Compatibility Test 5.PNG

This scenario describes a setup where the PBX and phones are in a private network. The IP800 must use a stun server, in order to send correct SIP - messages. The IP800 works as media relay, all RTP - streams go through the PBX.

Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

Basic Call

Tested feature Result
call using g711a Yes
call using g711u No
call using g723 No
call using g729 Yes
Overlapped sending No
early media channel Yes
Fax using T.38 Yes
CGPN can be supressed Yes
Reverse Media Negotiaton Yes
Voice Quality OK? Yes

Direct Dial In

Tested feature Result
Inbound(Provider -> Innovaphone) Yes
Outbound(Innovaphone -> Provider) Yes

DTMF

Tested feature Result
DTMF tones sent correctly Yes
DTMF tones received correctly Yes

Hold/Retrieve

Tested feature Result
Call can be put on hold Yes
Held end hears music on hold / announcement from PBX Yes

Transfer with consultation

Tested feature Result
Call can be transfered Yes
Held end hears music on hold Yes
Call returns to transferring device if the third

Endpoint is not available

Yes

Transfer with consultation (alerting only)

Tested feature Result
Call can be transfered Yes
Held end hears music on hold or dialing tone Yes
Call returns to transferring device if the third

Endpoint is not available

Yes

Blind Transfer

Tested feature Result
Call can be transfered Yes
Held end hears MoH Yes

Broadcast Group & Waiting Queue

Tested feature Result
Caller can make a call to a Broadcast Group Yes
Caller can make a call to a Waiting Queue Yes
Announcement if nobody picks up the call Yes

Configuration

Firmware version

All innovaphone devices use V6 SR2 HF6 as firmware.

SIP - Trunk

First of all the SIP Trunk must be configured. Since Hafslund authenticates a user account only by IP - Address, you cannot use the normal SIP-Gateway object. You need to configure a GW without registration and route the calls to the PBX.

Halfsund SIP Trunk - Halfsund - SIP Testreport 1.PNG

Number Mapping

Halfsund SIP Trunk - Halfsund - SIP Testreport 2.PNG

Route Settings

Because Hafslund, as most SIP - Providers too, doesn't support overlap sending, you must enable the blockwise sending of the phone number. You can do this by enabling Force enblock in your routes.

The second setting you must check is Interworking(QSIG,SIP). This feature must be enabled to properly relay suplementary services, like Hold over the SIP Trunk. If this checkbox is unchecked only basic call Information like connect and disconnect will be forwarded by the Gateway.

Halfsund SIP Trunk - Halfsund - SIP Testreport 3.PNG

Media Relay

By enabling Media Relay on the PBX, The IP800 will work as an RTP - Proxy, so all RTP Streams will travel through the IP800. This mode poses a much greater load on the PBX, so the number of concurrent calls will be heavy limited.

Halfsund SIP Trunk - Halfsund - SIP Testreport 4.PNG

You may wonder about the usefullness of putting the localhost address as a private network. However you must insert this entry, if the IP800 SIP GW registers at the PBX on localhost interface.

Fax