Howto:Lifesize - UVC Multipoint - TestReport
Summary
In order to have correct functionality we should register the UVC Multipoint in the PBX with SIP Protocol and not H.323.
It's necessary to set exclusive codec G711 a/u or G722 on the innovaphone IP Phones in order to have correct audio in the conference room. This not a normal behavior and should be fixed in future version of innovaphone firmware.
Both myPBX and LifeSize Endpoints were enable to join and speak in the same conference room. All endpoints were registered at Innovaphone PBX.
Certification Status
Testing of this product has been finalized April, 2013.
Version
- Lifesize UVC Multipoint - LS_MP_1.5.0(6)
- Innovaphone v10 Beta6
Test Setup
myPBX Tel1 uses IP110 - Extension 100
myPBX Tel2 uses IP232 - Extension 101
myPBX Tel3 uses Lifesize Softphone - Extension 102
Configuration
Innovaphone PBX
- Create PBX Gateway Object with number.
Lifesize UVC Multipoint
- Set SIP Configuration
- Create Conference Room
Test Results
UVC Multipoint - SIP GW With Registration Mode
Basic Operations Tested feature | Result |
---|---|
Tel1 and Tel2 call to 2001 Conference Room | OK |
Tel1 and Tel2 call to different Conference Rooms 2001 and 2002 | OK |
Tel1 calls to not existing Conference Room and it's answered by Virtual Operator | OK |
Tel1 and Tel3 call to 2001 Conference Room | OK |
Tel1 does hold/unhold inside Conference Room | OK |
Tel1 transfers Tel2 to 2001 Conference Room | X |
Tel1 Disconnect to Leave Room | OK |
Tel1 Calls to Conference Room using G711 Exclusive | OK |
Tel2 Calls to Conference Room using G722 Exclusive | OK |
UVC Multipoint Conference Webcontrol | Result |
---|---|
Mute/Unmute all Users | OK |
Mute/Unmute specific Users | OK |
Add Call | OK |
Disconnect All Users | OK |
Disconnect specific User | OK |
Test Notes
- It's necessary to set exclusive codec G711 a/u or G722 on the innovaphone IP Phones in order to have correct audio in the conference room.
Note: This was fixed already however not tested so if you face similar problem contact support.