Howto:M-net SIP Provider Compatibility Test
Innovaphone Compatibility Test Report
Summary
SIP Provider: M-net
The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.
That being said, the provider has achieved 90% of all possible test points (131/146). For more information on the test rating, please refer to Test Description
The SIP Provider supports NAT Detection and does not require media-relay. However it doesn't support T.38 and as a result the SIP trunk is not usable in hosting scenarios.
The support for at least one type of the G711 coder is mandatory, this provider supports G711a but not G711u.
Current test state
The tests for this product have been completed and it has been approved as a recommended product (Certification document).
Testing of this product has been finalized December 10th, 2013.
Testing Environment
This scenario describes a setup where the PBX and phones are in a private network.
- the SIP trunk is configured without Media Relay and without exclusive coder. This is the case if all tests were successful
Test Results
For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.
Basic Call
| Tested feature | Result |
|---|---|
| call using g711a | OK |
| call using g711u | NOK |
| call using g723 | NOK |
| call using g729 | OK |
| call using g722 | NOK |
| Overlapped sending | NOK |
| early media channel | OK |
| Fax using T.38 | NOK |
| Reverse Media Negotiation | OK |
| CGPN can be suppressed | OK |
| CLIP no screening | OK |
| Long time call possible(>30 min) | OK |
| External Transfer | OK |
| NAT Detection | OK |
| Redundancy | NOK |
| SIP over TCP | NOK |
| Voice Quality OK? | OK |
Direct Dial In
| Tested feature | Result |
|---|---|
| Inbound(Provider -> Innovaphone) | OK |
| Outbound(Innovaphone -> Provider) | OK |
| Loop In call(Innovaphone -> Provider -> Innovaphone) | OK |
DTMF
| Tested feature | Result |
|---|---|
| DTMF tones sent correctly | OK |
| DTMF tones sent correctly via SIP-Info | NOK |
| DTMF tones received correctly - WQ connect call | OK |
Hold/Retrieve
| Tested feature | Result |
|---|---|
| Call can be put on hold | OK |
| Held end hears music on hold / announcement from PBX | OK |
Transfer with consultation
| Tested feature | Result |
|---|---|
| Call can be transferred | OK |
| Held end hears music on hold | OK |
The following tests are made to test if call transfer is working.
| Tested feature | Voice Ok? | MoH Ok? |
|---|---|---|
| inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK | OK |
| inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK | OK |
| inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. inno1 transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK | OK |
Transfer with consultation (alerting only)
| Tested feature | Result |
|---|---|
| Call can be transferred | OK |
| Held end hears music on hold or dialling tone | OK |
| Call returns to transferring device if the third
Endpoint is not available |
OK |
The following tests are made to test if call transfer is working.
| Tested feature | Voice Ok? | MoH Ok? |
|---|---|---|
| inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK | OK |
| inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK | OK |
| inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. inno1 transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK | OK |
Blind Transfer
| Tested feature | Result |
|---|---|
| Call can be transferred | OK |
| Held end hears dialling tone | OK |
The following tests are made to test if call transfer is working.
| Tested feature | Voice Ok? | Dial Tone Ok? |
|---|---|---|
| inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK | OK |
| inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK | OK |
| inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. inno1 transfers to inno2. | OK | OK |
| sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK | OK |
CFU / CFB Transfer
| Tested feature | Result |
|---|---|
| Call can be forward | OK |
| Held end hears dialling tone | OK |
CFNR / Blind Transfer (alerting only)
| Tested feature | Result |
|---|---|
| Call can be transferred or forward | OK |
| Held end hears dialling tone | OK |
The following tests are made to test if call transfer is working.
| Tested feature | Voice Ok? |
|---|---|
| inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK |
| inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK |
| sip-provider-phone calls inno1. inno1 transfers to inno2. | OK |
Broadcast Group & Waiting Queue
| Tested feature | Result |
|---|---|
| Caller can make a call to a Broadcast Group | OK |
| Caller can make a call to a Waiting Queue | OK |
| Announcement if nobody picks up the call | OK |
Configuration
Firmware version
All innovaphone devices use V10 build 10.0941 as firmware.
SIP - Trunk
Number Mapping
Route Settings
- Force enblock is required for outgoing calls.