Howto:Sipcall business - SIP Provider Compatibility Test

From innovaphone wiki
Jump to navigation Jump to search

Innovaphone Compatibility Test Report

Summary

SIP Provider: sipcall business

The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.

The Reverse Media Negotiation is not supported, therefore Media Relay/RTP Proxy must be activated, in order to prevent media negotiation problems while transfer the calls.

T.38 is stated as supported, but no fax call was possible, due T.38 negotiation problems. The T.38 gateway on provider site exceeds the T4 timer of the T.30 protocol. As a result, fax calls with T.38 do not work.


That being said, the provider has achieved 89% of all possible test points. For more information on the test rating, please refer to Test Description


  • Features:
    • Direct Dial In
    • DTMF
  • Supported Codecs by the provider
    • G711
    • G729

Current test state

Recprod.PNG The tests for this product have been completed and it has been approved as a recommended product (Certification document).

Testing of this product has been finalized May 28th, 2010.

Testing Enviroment

Scenario NAT

HFO SIP Compatibility Test 5.PNG

This scenario describes a setup where the PBX and phones are in a private network. No STUN server is used and RTP Proxy activated on the PBX.


Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

Basic Call

Tested feature Result
call using g711a Yes
call using g711u Yes
call using g723 N/A
call using g729 Yes
Overlapped sending No
early media channel Yes
Fax using T.38 No
Reverse Media Negotiation No
CGPN can be suppressed No
CLIP no screening Yes
Long time call possible(>30 min) Yes
External Transfer Yes
NAT Detection Yes
Voice Quality OK? Yes

Direct Dial In

Tested feature Result
Inbound(Provider -> Innovaphone) Yes
Outbound(Innovaphone -> Provider) Yes

DTMF

Tested feature Result
DTMF tones sent correctly Yes
DTMF tones received correctly Yes

Hold/Retrieve

Tested feature Result
Call can be put on hold Yes
Held end hears music on hold / announcement from PBX Yes

Transfer with consultation

Tested feature Result
Call can be transferred Yes
Held end hears music on hold Yes

Transfer with consultation (alerting only)

Tested feature Result
Call can be transferred Yes
Held end hears music on hold or dialling tone Yes
Call returns to transferring device if the third

Endpoint is not available

Yes

Blind Transfer

Tested feature Result
Call can be transferred Yes
Held end hears dialling tone Yes

Broadcast Group & Waiting Queue

Tested feature Result
Caller can make a call to a Broadcast Group Yes
Caller can make a call to a Waiting Queue Yes
Announcement if nobody picks up the call Yes

Configuration

Firmware version

All innovaphone devices use V8 hotfix2 build 80500.04 as firmware.

SIP-Trunk

The SIP interface must be configured to act always as media relay, since no reverse media negotiation is supported. Also codec as exclusive must be activated in order no renegotiation can happen.

The From Header and Identity Header must be configured to send CGPN in user part of URI and Fixed AOR, in order the DDI works correctly.


Sipcall business SIP Provider Compatibility Test SIP interface 01.png

Number Mapping

For 10 Numbers Block from +41325105070 to +41325105079, following number maps are configured:


Sipcall business SIP Provider Compatibility Test-2.png

Route Settings

Enblock dialling must be activated, since no overlap dialling is supported.

Interworking should not be activated, because it will disable PBX internal MoH and Provider will play MoH instead.


Howto Sipcall business SIP Provider Compatibility Test routes 01.png

Media Relay

Media relay must be configured on SIP interface, since no reverse media negotiation is supported.