Reference10:User Configuration/

This page allows the SoftwarePhone user to configure some application and audio device settings without administrator access to SoftwarePhone's main configuration System. It can only be accessed from the same computer where softwarephone is running.

Application Run Mode

Manual

• SoftwarePhone must be started via the Start Menu entry.

Login

• SoftwarePhone will be started automatically during User Login.

Application Priority

Normal

• Softwarephone runs at standard Windows process priority. Usually this setting is sufficient.

High

• If you experience delays or pauses during a conversation and your computer runs at high load this may improve the audio stream throughput.

Audio Input Device

• Select from the microphones which are identified by SoftwarePhone on your computer.

Audio Output Device

• Select from the speakers which are identified by SoftwarePhone on your computer.

Audio Ringing Device

• This determines on which device an incomming call is signalled. Select from the speakers which are identified by SoftwarePhone on your computer.

USB Device

• Select from the USB Audio devices identified by SoftwarePhone on your computer. Select here the same device that you selected in the "Audio Input/Output Device" configuration menu(if present here as well). If the device you selected in the "Audio" menus is not listed here the Audio device is not a USB telephony device and you can omit this configuration setting.

USB Map

• Select the corresponding entry to your "USB Device" Setting or, if not listed, the "generic HID Telephony Page".

Note: If your Headset is not listed here or the correspondig map file is not listed and the "generic HID Telephony Page" selection does not enable the onhook/offhook call control you call still use this device as Audio input/output/ringing device. In this case the call control must be done exclusively by myPbx. Volume controls on your Headset (if present) can be used independantly of this configuration