Reference8:Configuration/DECT/Master
Jump to navigation
Jump to search
There are also other versions of this article available:
Reference | Reference8 (this version) | Reference9 | Reference11r1
It is necessary to configure the operating mode of the DECT system. A gatekeeper must also be specified here, on which the innovaphone PBX component is operated.
- Mode: Active switches on the DECT master function. In every DECT system, there must be a DECT master.
- Off switches off the DECT master function.
- Active switches on the DECT master function.
- Standby switches on the standby function for the DECT master.
- Deployment switches on the deployment mode for the DECT master.
- Primary Master IP Address: This field is only visible if this device has been configured as Standby-Master (Mode = Standby). The IP address of the DECT-Master has to be configured here.
- Prot: The protocol to be used for the communication. There is a choice between:
- H.323 (RFC 1889), which is the recommended protocol for innovaphone VoIP devices, since it implements most features.
- SIP (RFC 3261).
- GK: The IP address of the primary gatekeeper. The device on which the innovaphone PBX component is operated.
- Alt GK: The IP address of the secondary, alternative gatekeeper.
- GK ID: The gatekeeper ID of the gatekeeper to be used. It is required to configure a gatekeeper ID if in the DECT Master device a PBX is also active.
- STUN Server: STUN server to be used if DECT master has no public ip address and SIP server is outside the local network.
- Name for Authentication: Some SIP PBXs need authentication name different from the registration id. This enables the number being used as id and the name for authentication.
- Redirection with GK ID: If enabled and the user registration is redirected, the GK ID of the redirecting PBX is appended to the registration to the redirected PBX.
- Enbloc Dialing: If enabled, the dialed numbers will be sent together within the setup message after timeout.
- Send inband DTMF: If enabled, DTMF will be sent as inband DTMF.
- Allow DTMF through RTP: If enabled, DTMF capability through RTP is allowed.
- Enable messaging to PBX: Message will be send via SIP or H.323, if disabled messages will be sent via the Polycom MSF-Module. Hotfix 8 and later: moved to Messaging page.
- Idle Display Update: Enables idle display updates.
- Disable broadcast delay: For small installations it is not necessary to delay the broadcasts for incoming calls to the radios. Enabling this option is not recommended for big systems.
- Response timeout: If the timeout is configured and the handset is not in range, the call is released with cause 'No user responding' after the timeout.
- LDAP Directory Search: If enabled and a Ldap server is configured, the IP1200 does a LDAP directory look up for incoming calls. Shows up the callers name on the Dect phones.
- Registration for anonymous devices: The anonymous registered devices use this registration to make a call. (Normally handsets logged in as anonymous user cannot place calls, since they have no registration to the PBX. This includes also emergency calls. If a registration is entered here, all anonymous handsets use this registration for outbound calls.)
- Deactivate Master if no connection: If the registration is configured but can not be established the master is turned off.