Howto:FR - Linkt - TRUNK SIP SIP-Provider (2023)
Tests for the TRUNK_SIP SIP trunk product of the provider Linkt were completed. Test results have been last updated on March 21st, 2023. Check the history of this article for the date of the first publication of the testreport. <internal>Provider SBC: </internal>
List of Issues found in media-relay Configuration
- 180 RINGING
- The provider does not send a
180 Ringingresponse when the called party alerts.
- FAX T38 ONNET
- The provider does not support T.38 fax for onnet calls.
- FAX T38
- The provider does not fully support T.38 fax
- FAX T38ANDAUDIO
- The provider does not support fallback to audio-fax if T.38 fails.
- The provider can not send DTMF signals via SIP-INFO messages.
- REVERSE MEDIA
- The provider does not support reverse media negotiation (a.k.a. late SDP)
- SIP INFO
- The provider does not support conveying DTMF using the SIP-INFO method.
Here is the list of test-cases that have been performed for this provider: XFER_BLIND, 180_RINGING, BASIC_CALL, CLIR, CLNS_ONNET, CLNS, CONN_NR_DIFF, CONN_NR_INCOMING, CONN_NR, DTMF, EARLY_MEDIA_INBOUND, FAX_AUDIO, FAX_T38_ONNET, FAX_T38, FAX_T38ANDAUDIO, G711A_ONNET, G711A, G711U_ONNET, G711U, G722_ONNET, G722, G729_ONNET, G729, HOLD_RETRIEVE, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, MOBILITY, OPUS_NB, OPUS_WB, RALERT_DISC, REDIR_302, REDIR_DIVHDR, REDIR_HISTHDR, REVERSE_MEDIA, SDP_ICE, SDP_RTCP_MUX, SDP_VIDEO, SIP_INFO, SRTP_INCOMING, SRTP_INTERNAL, SRTP_OUTGOING, SUBSCRIBER_NR, XFER_CONS_ALERT, XFER_CONS_EXT, XFER_CONS
This SIP provider requires a media-relay configuration. That is, all media traffic between the SIP provider and all endpoints must flow through the SBC. For this reason, a configuration without media-relay has not been tested and hence no test results for this configuration are listed.
Configuration with media-relay
- Signalling protocol
- The provider supports UDP and TCP as transport protocol. The tests were completed using TCP, since UDP is an unreliable protocol and requires all involved network elements to support IP-fragmentation.
- NAT Traversal
- The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.
- DTMF (RFC2833)
- The provider can convey DTMF digits using the RTP payload method as per RFC2833.
- Session Timer
- The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
- Currently we don't test the redundancy for SIP-trunks without registration.
- Call Transfer
- Correct signalling of Ringing-state
- Ringing is not signalled by the provider. This will lead to incorrect call-state display on the PBX (phone-UI, myPBX, Soap) for outbound calls to the PSTN. The caller will see no status-update on the phone-display/PC-screen, showing that the remote party was reached and is ringing.
- Additionally external callers forwarded/transferred back to the PSTN, may get no ring-tone but hear silence while the remote party is ringing. This silence while waiting might lead to aborting the call. As a result, Carrier w/o Alerting is required in all PBX 'Mobility' objects.
- Clip No Screening (CLNS)
- Straight clip no screening (i.e. sending a foreign number as calling line id) works fine. As this works anyway, it does not matter, if the provider supports the interpretation of
Diversion:SIP headers for providing the correct calling line id for diverted calls. This provider supports call redirection using the SIP 302 Redirect header. Rerouting can be enabled by setting the Reroute supported check-mark in the corresponding Trunk object configuration. Also, the Interworking check-mark must be set in the route used for calls from and to the SIP provider.
- However, during our test other interop problems were discovered when the Interworking Flag is enabled. Therefore it is not recommended to use the call redirection via SIP 302 Redirect header.
- Outbound and inbound calls to/from the PSTN show the correct connected number.
- For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
- The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
- Transport of faxes to/from the PSTN via G.711 codec was tested successfully.
- Transport of faxes using T.38 failed to PSTN and onnet destinations. Moreover fallback to audio-fax failed also.
- As a result, T.38 is disabled on the SIP-interface and the use of audio-fax is necessary.
- supported to/from PSTN: G711A
- supported onnet (VoIP to VoIP): G711A
- Large SIP messages
- Reverse Media Negotiation
- Reverse-media negotiation is not supported. Therefore, a media-relay with exclusive coder configuration will be activated on the SIP-interface.
- Mobility Calls
- Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.
- As the provider does not provide proper alert signalling, you will need to configure the Carrier w/o Alerting check-mark in the PBX Mobility object.
- The provider does not support audio encryption using SRTP.
- Dialing of Subscriber Numbers
- The provider does not support dialling numbers in subscriber number format. Make sure to configure the Dialing Location accordingly.
Use profile FR-Linkt-TRUNK_SIP in Gateway/Interfaces/SIP to configure this SIP provider.
Please note the following configuration hints:
- Alert not signalled, 'Carrier w/o Alerting' required in all PBX 'Mobility' objects
- Dialling of subscriber numbers not possible, 'Dialing Location' must be configured without 'Area Code'
- This is a SIP account without registration. Depending on the provider a firewall rule is necessary.
- A most recent v13r3 firmware is required to use this SIP-profile. For hints regarding upgrade to v13r3, see Howto:V13_Firmware_Upgrade_V13r2_V13r3
These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.
All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.
If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.
Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.
Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.