Howto:SIP-Trunk - CM - SIP Provider

From innovaphone-wiki

Innovaphone Compatibility Test Report

Contents 1 Summary 2 Current test state 3 Testing Enviroment 4 Test Results 4.1 Basic Call 4.2 Direct Dial In 4.3 DTMF 4.4 Hold/Retrieve 4.5 Transfer with consultation 4.6 Transfer with consultation (alerting only) 4.7 Blind Transfer 4.8 CFU / CFB Transfer 4.9 CFNR / Blind Transfer (alerting only) 4.10 Broadcast Group & Waiting Queue 5 Configuration 5.1 Firmware version 5.2 SIP - Trunk 5.3 Route Settings 5.4 Mapping Settings

[edit] Summary

SIP Provider: CM

The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.

That being said, the provider has achieved 83,6% of all possible test points. For more information on the test rating, please refer to Test Description

• Features:
  • Direct Dial In
  • DTMF
  • Redundancy

• Supported Codecs by the provider
  • G711
  • G729
  • G723
  • G722

[edit] Current test state

This product is being tested right now. The test is not yet completed.

[edit] Testing Enviroment

This scenario describes a setup where the PBX and phones are in a private network.

• the SIP trunk is configured with Media Relay and with exclusive coder. This is the case if all tests were successful

[edit] Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

[edit] Basic Call

Tested feature	Result
call using g711a	OK
call using g711u	OK
call using g729	OK
call using g722	OK
Overlapped sending	OK
early media channel	OK
Fax using T.38	NOK
T.38 Transcoding by the provider	NOK
Reverse Media Negotiation	n/a
CGPN can be suppressed	OK
CLIP no screening	OK
Long time call possible(>30 min)	OK
External Transfer	OK
NAT Detection	OK
Redundancy	OK*
SIP over TCP	NOK
SIP over UDP	OK
Voice Quality OK?	OK

* Note to Redundancy: Redundancy it's possible configuring a second outbound SIP trunk to a secondary SIP server from the provider

[edit] Direct Dial In

Tested feature	Result
Inbound(Provider -> Innovaphone)	OK
Outbound(Innovaphone -> Provider)	OK
Loop In call(Innovaphone -> Provider -> Innovaphone)	OK

[edit] DTMF

Tested feature	Result
DTMF tones sent correctly via RTP-events(RFC 2833)	OK
DTMF tones sent correctly via SIP-Info	NOK
DTMF tones received correctly via RTP-events(RFC 2833)	OK

[edit] Hold/Retrieve

Tested feature	Result
Call can be put on hold	OK
Held end hears music on hold / announcement from PBX	OK

[edit] Transfer with consultation

Tested feature	Result
Call can be transferred	OK
Held end hears music on hold	OK

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?	MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.	OK	OK
inno1 calls PSTN-phone. inno1 transfers to inno2.	OK	OK
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.	OK	OK
PSTN-phone calls inno1. inno1 transfers to inno2.	OK	OK
PSTN-phone calls inno1. PSTN-phone transfers to inno2.	OK	OK
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.	OK	OK

[edit] Transfer with consultation (alerting only)

Tested feature	Result
Call can be transferred	OK
Held end hears music on hold or dialling tone	OK
Call returns to transferring device if the third Endpoint is not available	OK

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?	MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.	OK	OK
inno1 calls PSTN-phone. inno1 transfers to inno2.	OK	OK
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.	OK	OK
PSTN-phone calls inno1. inno1 transfers to inno2.	OK	OK
PSTN-phone calls inno1. PSTN-phone transfers to inno2.	OK	OK
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.	OK	OK

[edit] Blind Transfer

Tested feature	Result
Call can be transferred	OK
Held end hears dialling tone	OK

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.	OK
inno1 calls PSTN-phone. inno1 transfers to inno2.	OK
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.	OK
PSTN-phone calls inno1. inno1 transfers to inno2.	OK
PSTN-phone calls inno1. PSTN-phone transfers to inno2.	OK
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.	OK

[edit] CFU / CFB Transfer

Tested feature	Result
Call can be forward	OK
Held end hears dialling tone	OK

[edit] CFNR / Blind Transfer (alerting only)

Tested feature	Result
Call can be transferred or forward	OK
Held end hears dialling tone	OK

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.	OK
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.	OK
PSTN-phone calls inno1. inno1 transfers to inno2.	OK
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.	OK

[edit] Broadcast Group & Waiting Queue

Tested feature	Result
Caller can make a call to a Broadcast Group	OK
Caller can make a call to a Waiting Queue	OK
Announcement if nobody picks up the call	OK

[edit] Configuration

[edit] Firmware version

All innovaphone devices use V13r3 SR2.

[edit] SIP - Trunk

[edit] Route Settings

[edit] Mapping Settings