From innovaphone wiki
Jump to navigation Jump to search
There are also other versions of this article available: Reference | Reference9 (this version)

Depending on device, this menu shows you whether a CF card is being used. Please note that the devices support the FAT32 format only. To be able to use the CF card properly, it must be formatted accordingly beforehand. The card can only be formatted if it is first unmounted' using the umount or remove button.

 The card is only really unmounted if no folders or files are being accessed any more.
 If, for example, voicemail that is on the CF card is accessed, 
 then the block and the subsequent formatting only take effect when the voicemail is no longer being accessed.

To transfer files to the CF card, the card must be connected as a network drive. This is only possible in a mounted state. Should the CF card be unmounted, it must be mounted using the mount button.

 To be able to connect the CF card as a network drive, the following path must be used:
 "\\<IP address of the gateway>\DRIVE\CF0".
 User and password correspond to the user and password as configured in chapter "Configuration/General/Admin".

Supported card sizes

The firmware supports CF cards up to 128GB. Greater cards can be also used, if formatted inside the firmware, but just up to 128GB can be accessed!
If you run a Linux on the card, the size does not matter, as Linux supports cards greater than 128 GB.


The following buttons are available:


Shows some usefull infos, e.g. the available free space.


Mounts/unmounts the CF card. If the card is not mounted, it cannot be accessed. It can however be formatted or a checkdisk can be run. If there are open files or folders, the card won't be unmounted and the files/directories will be listed, so that the administrator can decide if an unmount with 'Remove' is secure.


Also unmounts the CF card if files or directories are currently opened. Necessary operations will be finished, so that there will be no data inconsistency, but e.g. log files will be closed.


Checks the CF card for errors.


Formats the CF card in the FAT32 format.
Use the checkbox Format the whole flash disk and remove exisiting partitions? if you also want to erase partitions (e.g. if you had installed a Linux Application Platform image).

Browse CF Content

Allows you to browse through the CF card's content. Please note that the flash file system implementation will always show file creation timestamps rather than file modification timestamps (neither modification time stamps nor the archive bit are maintained for speed).