Howto:Bypass the setup wizard/install: Difference between revisions
Jump to navigation
Jump to search
(Correcting, ref support case 32419) |
|||
Line 4: | Line 4: | ||
* all innovaphone devices, | * all innovaphone devices, | ||
Firmware V6 SR2 and later. | Firmware V6 SR2, first hotfixes, see chapter 2.1 | ||
Firmware V6 SR2, hotfix 5 and later, see chapter 2.2 | |||
<!-- Keywords: enter keywords, foreign translations and/or synoyms not appearing in the article here for better search results --> | <!-- Keywords: enter keywords, foreign translations and/or synoyms not appearing in the article here for better search results --> |
Revision as of 09:57, 5 August 2008
Applies To
This information applies to
- all innovaphone devices,
Firmware V6 SR2, first hotfixes, see chapter 2.1 Firmware V6 SR2, hotfix 5 and later, see chapter 2.2
More Information
Problem Details
From Version 6, Service Release 2 on, innovaphone devices will run a configuration wizard when accessed reset to factory settings. While this is great to speed up deployment of innovaphone boxes, it may be required to bypass the wizard in certain situations.
Resolution
To bypass the wizard, access http://x.x.x.x/admin.htm
instead of http://x.x.x.x
to access the standard configuration interface.