Howto:QSC IPfonie extended - SIP Provider Compatibility Test: Difference between revisions
m (→Configuration) |
|||
Line 322: | Line 322: | ||
== Configuration == | == Configuration == | ||
<!-- | |||
=== Firmware version === | === Firmware version === | ||
Line 370: | Line 370: | ||
<nowiki>http://PBX-IP-address/!config write</nowiki> | <nowiki>http://PBX-IP-address/!config write</nowiki> | ||
<nowiki>http://PBX-IP-address/!config activate</nowiki> | <nowiki>http://PBX-IP-address/!config activate</nowiki> | ||
--> | |||
== Related Articles == | == Related Articles == |
Revision as of 12:57, 4 October 2012
Innovaphone Compatibility Test Report
Summary
SIP Provider: QSC
- Features:
- Direct Dial In
- DTMF
- Supported Codecs by the provider
- G711
- G729
- G723
- T.38
The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.
The configuration on innovaphone side is simple, since the built-in SIP-GW can be used to connect to the provider.
QSC has achieved 98% of all possible test points. For more information on the test rating, please refer to Test Description
Current test state
This product is being tested right now. The test is not yet completed.
Testing Enviroment
Scenario NAT
This scenario describes a setup where the PBX and phones are in a private network. The IP800 must use a stun server, in order to send correct SIP - messages. The IP800 works as media relay, all RTP - streams go through the PBX.
Test Results
For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.
Basic Call
Tested feature | Result |
---|---|
call using g711a | |
call using g711u | |
call using g723 | |
call using g729 | |
call using g722 | |
Overlapped sending | |
early media channel | |
Fax using T.38 | |
Reverse Media Negotiation | |
CGPN can be suppressed | |
CLIP no screening | |
Long time call possible(>30 min) | |
External Transfer | |
NAT Detection | |
Redundancy | |
SIP over TCP | |
Voice Quality OK? |
Direct Dial In
Tested feature | Result |
---|---|
Inbound(Provider -> Innovaphone) | |
Outbound(Innovaphone -> Provider) |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | |
DTMF tones sent correctly via SIP-Info | |
DTMF tones received correctly |
Hold/Retrieve
Tested feature | Result |
---|---|
Call can be put on hold | |
Held end hears music on hold / announcement from PBX |
Transfer with consultation
Tested feature | Result |
---|---|
Call can be transferred | |
Held end hears music on hold |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | ||
inno1 calls inno2. inno1 transfers to sip-provider-phone. | ||
inno1 calls sip-provider-phone. inno1 transfers to inno2. | ||
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | ||
sip-provider-phone calls inno1. inno1 transfers to inno2. | ||
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Call can be transferred | |
Held end hears music on hold or dialling tone | |
Call returns to transferring device if the third
Endpoint is not available |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | ||
inno1 calls inno2. inno1 transfers to sip-provider-phone. | ||
inno1 calls sip-provider-phone. inno1 transfers to inno2. | ||
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | ||
sip-provider-phone calls inno1. inno1 transfers to inno2. | ||
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. |
Blind Transfer
Tested feature | Result |
---|---|
Call can be transferred | |
Held end hears dialling tone |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | |
inno1 calls inno2. inno1 transfers to sip-provider-phone. | |
inno1 calls sip-provider-phone. inno1 transfers to inno2. | |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | |
sip-provider-phone calls inno1. inno1 transfers to inno2. | |
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. |
Blind Transfer (alerting only)
Tested feature | Result |
---|---|
Call can be transferred | |
Held end hears dialling tone |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | |
sip-provider-phone calls inno1. inno1 transfers to inno2. |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | |
Caller can make a call to a Waiting Queue | |
Announcement if nobody picks up the call |