Reference9:3pty conference on DECT phones: Difference between revisions
Line 24: | Line 24: | ||
== Related Articles == | == Related Articles == | ||
[[Reference9:Gateway/Interfaces#Conferencing_interface_.28CONF.29 | Gateway CONF Interface]] | * [[Reference9:Gateway/Interfaces#Conferencing_interface_.28CONF.29 | Gateway CONF Interface]] | ||
* [[Reference9:DECT2/Config/Master | Configuration DECT Master]] | |||
[[Reference9:DECT2/Config/Master | Configuration DECT Master]] | * [[Support:DVL-Roadmap_Firmware_V9#IP-DECT:_Three_party_conference_with_innovaphone_PBX | V9 Hotfix11: IP-DECT: Three party conference with innovaphone PBX]] | ||
* [[Howto:Conferences, Resources and Licenses]] | |||
[[Support:DVL-Roadmap_Firmware_V9#IP-DECT:_Three_party_conference_with_innovaphone_PBX | V9 Hotfix11: IP-DECT: Three party conference with innovaphone PBX]] |
Revision as of 18:35, 20 March 2014
This article explains how to configure and use 3pty conference calls on DECT phones.
Applies To
This information applies to
- all innovaphone DECT devices (IP1200 and IP1202) from V9HF11.
More Information
The innovaphone IP-DECT devices are able to use the innovaphone conference hardware (CONF interface) to establish a 3pty conference call with firmware V9 hotfix 11 or later. If the 3pty conference is started by the user, first the IP-DECT device starts a call to the configured conferencing unit number. If this call connects, the connected number is used to connect the other call parties to the conference call.
Requirements
- innovaphone IP-DECT device with firmware V9 hotfix 11 or later
- innovaphone device with CONF interface with support of connected number (V9 and later)
Configuration
- PBX: The innovaphone CONF interface is registered to a PBX Trunk Line object (or a Gateway object with the Prefix check-mark ticked). The Trunk Line must have a number and be called by the gatekeeper the DECT users are registered.
- IP-DECT device: The Conferencing Unit Number of the DECT Master is to be set to the Trunk Line number appended by *1#.
Usage
To start a conference by a DECT phone use the R-key feature R+3 during a call. You must have at least one inactive call. To stop the conference again use also R+3. R+2 stops the conference and toggles to the last inactive party, or to a waiting call, if present.