Reference:Administration/Relay/Routes/Map

This page is used to edit a Number map.

Configuration

'
Description	This description is displayed in the last coloum of the routing table. It can be used for documentation purposes.
Disable	The Disable checkmark disables a route without deleting it. This way a route can be disabled temporarily without the need to re-enter all the configuration if it is enabled again.
From Interfaces	All available interfaces are displayed. By setting the checkmark next to an interface, this interface is added to the list of interfaces for which the route handles incoming calls. Even if this is a page to edit a map the From interface list is valid for the route. It cannot be modified for a single map only.
Number In/Out	The Number In/Out input fields (input fields with no label but an arrow in between) are used to do a headmatch on the received called party number and replace the matching part of the called party number by Number Out. As digits any valid dialing digit is allowed (0..9,*,#). A '?' as digit in Number in indicates that this digit matches to any received digit. '.' at the end of Number In can be used to indicate that the number should match only if the respective number of additional digits is received. Any digits matching with '.' are not replaced by Number Out. This way a conversion of overlap to en-block dialing can be performed. A '!' at the end of Number In indicates that any additional digit received after it, should be cut off.
Name Out	The name in the Name Out field (the field without label below Number Out) is sent as destination name with the call.
To Interface	The drop down is used to select the interface to which the call is sent if the map matches. There are two pseudo interfaces available: DISC and MAP. DISC disconnects the call if the map matches. MAP just does the number mapping as configured and the searching for routes will continue.
DISC