Howto:Innovaphone Phones on FritzBox
Applies To
This information applies to
innovaphone IP Phones User Configuration for registering on FritzBox
More Information
Configuration FritzBox User
Configurate a User on FritzBox like this:
Remark: According to experiences with current hard- and software (FB7590, 7.00), selected password (Kennwort) must not equal choosen username (Benutzername). Although no error is displayed, later on phone login will just not work.
Configuration innovaphone User Config
Login to the webbased user interface of the phone via webbrowser. Insert ip-adress of phone to your browser and login with userid "admin" and password "ipxxx" where xxx stands for the phone type (e.g. IP232 has default password "ip232").
Then step to Phone/User-1 and configure the innovaphone user with the data used in FritzBox like this:
Configuration Message Waiting Key
innovaphone phones support RFC 3842 which defines SIP based message waiting procedure.
This enables definition and use of message waiting function key and lamp to access FritzBox-built-in voicemail service.
By default, FritzBox-VM owns number **600. Any further described configuration assume this as default. If this is changed by user or manufacturer, configuration below has to be adapted.
Control of MWI-LED and voicemail access via function key requires definition of both number and name as follows:
- Number: <FritzBox-VM>@fritz.box - default **600@fritz.box ; do NOT tick Append Own Number
- Name: <username>@fritz.box
Voicemail on/off Key
Add an "Dial" function key. Insert in Action>Number the Fritz-Box-VM owns number **600, followed from one waiting command "," and the FritBox-VM DTMF Command for on/off "3".