Howto:Adjusting volume parameters on IP200A in Version 5 Firmware
This Howto describes the configuration of the volume parameters for user of an IP110, IP200A and IP230.
Applies To
This information applies to
- IP 110
- IP 200A
- IP 230
Version 5 Firmware. For Version 6, see a separate article!
More Information
Problem Details
In some cases the default parameters are not perfectly matching the customer requirements. For those issues you have to rearrange the volume parameters.
At the phone, there are two amplifiers, one analogue and one digital, seperatly adjustable.
Tip! Try to keep down the analogue amplification.
Configuration
First try the default configuration.
Otherwise change the parameters as described below.
As a good parameter set we prefer the following:
config change INCA_DSP /afe-gain ,,,,176,176
config change /PHONECFG0 /headset 8
Analogue Amplification
The analogue amplification of the speaker output can be changed by pressing the left/right arrow keys in calling mode. This configuration will be kept in nonvolatile memory at the call end and automaticly loaded in the next call. This parameters are stored in PHONECFG0.
The default settings of analogue amplification for handset, headset and handsfree microphone are:
handset – 5 ; headset – 6 ; handsfree – 5
Those values can be changed with:
config change PHONECFG0 /handset 0..8 /headset 0..8 /handsfree 0..8 config activate
To increase the Mic volume of the headset use:
config change PHONECFG0 /headset 8 config activate
Digital Amplification
The IP110, IP200A and IP230 are providing many more options on the DSP as an IP200. To configure these options below add them in this configuration line:
config change INCA_DSP /option parameters
Option | Parameters | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ring tones | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/ring-gain | 176, | 0, | 176, | 180, | 180 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
afe gain analog -> digital | afe gain digital -> analog | output gain | tone generator gain | saturation gain | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
notification tones (call waiting...) | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/notify-gain | 140, | 152, | 140, | 140, | 0, | 0, | 180, | 180 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
call waiting | partner & pickup | announce | multicast | reserved | reserved | tone generator gain | saturation gain | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
DTMF tones | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/dtmf-gain | 0xc0, | 0x7f, | 0x7f | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
output gain - 0x10…0xff | frequency 1 level - 0x00…0x7f | frequency 2 level - 0x00…0x7f | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
calling tones (alerting, busy, …) | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/tone-gain | 0xc0, | 0x7f, | 0x7f | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
output gain - 0x10…0xff | frequency 1 level - 0x00…0x7f | frequency 2 level - 0x00…0x7f | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
analog front end (handsfree, handset, headset) | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/afe-gain | 169, | 169, | 176, | 176, | 176, | 176 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
handsfree AD/DA | handset AD/DA | headset AD/DA | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
handset sidetone gain | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/handset-sidetone | 5 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
sidetone gain, 0…100, 0 = max sidetone | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
headset sidetone gain | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/headset-sidetone | 5 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
sidetone gain, 0…100, 0 = max sidetone | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ringing through headset | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/headset-ring | 1 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ring through headset volume, 0...12, 0 = off | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
monitor headset via handset | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
/headset-spy | 0 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
handset speaker volume, 0...9, 0 = off |
The first value of a value pair defines the Analog to Digital gain, i.e. the microphone gain, the second the Digital to Analog gain, i.e. the speaker gain.
The values can vary in the range from 0 to 200 but usually values between 160 and 190 will give the expected results.