Howto:Arcor-IP Anlagenanschluss - Arcor - SIP Testreport
Innovaphone Compatibility Test Report
Summary
SIP Provider: Arcor
The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.
Arcor does not support the T.38 protocol, therefore you cannot send faxes using this SIP trunk.
That beeing said, the provider has achieved 87% of all possible test points. For more information on the test rating, please refer to Test Description
- Features:
- Direct Dial In
- DTMF
- Supported Codecs by the provider
- G711
- G729
Certification Status
The tests for this product have been completed and it has been approved as a recommended product (Certification document).
Testing of this product has been finalized August 20th, 2008.
Testing Enviroment
Scenario
This scenario tries to be as simple as possible. The IP - PBX and the phones are all in the same network, having public IP - adresses. The signalling channel will pass through the PBX, the media channel will go from endpoint (phone) to endpoint (provider).
Test Results
For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.
Basic Call
Tested feature | Result |
---|---|
call using g711a | Yes |
call using g711u | Yes |
call using g723 | No |
call using g729 | Yes |
Overlapped sending | No |
early media channel | Yes |
Fax using T.38 | No |
CGPN can be supressed | No |
Reverse Media Negotiaton | Yes |
Voice Quality OK? | Yes |
Direct Dial In
Tested feature | Result |
---|---|
Inbound(Provider -> Innovaphone) | Yes |
Outbound(Innovaphone -> Provider) | Yes |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | Yes |
DTMF tones received correctly | Yes |
Hold/Retrieve
Tested feature | Result |
---|---|
Call can be put on hold | Yes |
Held end hears music on hold / announcement from PBX | Yes |
Held end hears music on hold / announcement from provider | N/A |
Transfer with consultation
Tested feature | Result |
---|---|
Call can be transfered | Yes |
Held end hears music on hold | Yes |
Call returns to transferring device if the third
Endpoint is not available |
Yes |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Call can be transfered | Yes |
Held end hears music on hold or dialing tone | Yes |
Call returns to transferring device if the third
Endpoint is not available |
Yes |
Blind Transfer
Tested feature | Result |
---|---|
Call can be transfered | Yes |
Held end hears dialing tone | No |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | Yes |
Caller can make a call to a Waiting Queue | Yes |
Announcement if nobody picks up the call | Yes |
Configuration
Firmware version
All innovaphone devices use V6 SR2 HF7 as firmware.
SIP - Trunk
First of all the SIP Trunk must be configured. Since Arcor authenticates a user account only by IP - Address, you cannot use the normal SIP-Gateway object. You need to configure a GW without registration and route the calls to the PBX.
Number Mapping
Route Settings
Because Arcor, as most SIP - Providers too, doesn't support overlap sending, you must enable the blockwise sending of the phone number. You can do this by enabling Force enblock in your routes.
The second setting you must check is Interworking(QSIG,SIP). This feature must be enabled to properly relay suplementary services, like Hold over the SIP Trunk. If this checkbox is unchecked only basic call Information like connect and disconnect will be forwarded by the Gateway.
Configuration 2017
Firmware version
12r1 sr11
SIP-Trunk
http://wiki.innovaphone.com/img_auth.php/e/ee/1siptrunk.png
Number Mapping
http://wiki.innovaphone.com/img_auth.php/8/8a/2numberplan.png
Route Settings
http://wiki.innovaphone.com/img_auth.php/7/7f/3routes.png
At the last Point (-> SIP1:VodafoneSIP) add the UUI: <sip:+49789123450@DOMAIN-FROM-ARCOR;user=phone>