Howto:Bypass the setup wizard/install: Difference between revisions
(remove auto http link) |
|||
| Line 21: | Line 21: | ||
You can do that by doing the commands: | You can do that by doing the commands: | ||
<pre> | |||
http://x.x.x.x/!config change HTTP0 | http://x.x.x.x/!config change HTTP0 | ||
http://x.x.x.x/!config write | http://x.x.x.x/!config write | ||
http://x.x.x.x/!config activate | http://x.x.x.x/!config activate | ||
http://x.x.x.x/!ireset | http://x.x.x.x/!ireset | ||
</pre> | |||
<!-- == Related Articles == --> | <!-- == Related Articles == --> | ||
[[Category:Howto|{{PAGENAME}}]] | [[Category:Howto|{{PAGENAME}}]] | ||
Revision as of 14:00, 12 June 2017
Applies To
This information applies to
- all innovaphone devices,
Firmware V6 SR2 and later.
More Information
Problem Details
From Version 6, Service Release 2 on, innovaphone devices will run a configuration wizard when accessed reset to factory settings. While this is a great to speed up deployment of innovaphone boxes, it may be required to bypass the wizard in certain situations.
Resolution
To bypass the wizard, access http://x.x.x.x/admin.htm (or http://x.x.x.x/administrator.htm for V7 and later) instead of http://x.x.x.x to access the standard configuration interface.
Nb: from version 9 firmware on, the URL to bypass the wizard is http://x.x.x.x/admin.xml?xsl=admin.xsl.
To get rid of the wizard permanently, you may remove the /home SETUP/wizard.xml parameter from the config change HTTP0 line.
You can do that by doing the commands:
http://x.x.x.x/!config change HTTP0 http://x.x.x.x/!config write http://x.x.x.x/!config activate http://x.x.x.x/!ireset