Howto:Change the volume of the pickup key audio notification
Applies To
This information applies to
- IP phones, v9
More Information
The Pickup key can be configured to generate an "Audible Signal after alerting [sec]".
Since V9hotfix24 the volume of this Audible Signal is bound to the volume configured for the internal ring tone, prior to this hotfix the volume was fixed.
On any phone the volume of the Audible Signal can be set to a fixed value by
config add PHONE SIG /notify-pickup-gain <gain>
The parameter <gain> allows values from 1 to 10. Which value is most suitable needs to be tried with the phone in question.
For the phones IP 110/150/200A/230/240 it is possible to configure the volume of the Audible Signal as described in this article.
This method is deprecated because it is rather complicated and does not work for the new series of IP phones(IP 222/232/241).
If a phone was configured this way it's recommended to remove the corresponding configuration parameter by
config rem INCA_DSP RINGER /notify_pickup_tgen_coeff_G01
and to use the new simpler method if necessary.