Howto:DHSG pin assignment: Difference between revisions
Jump to navigation
Jump to search
(New page: Here is the pin assignment for the DHSG headset interface. This interface is standardized, so it will be identical for all DHSG phones, not only the IP230. You should be able thus to obt...) |
mNo edit summary |
||
| Line 5: | Line 5: | ||
Assignement: | Assignement: | ||
pin 1 - bus send | * pin 1 - bus send | ||
pin 2 - 0V | * pin 2 - 0V | ||
pin 3 - microphone | * pin 3 - microphone | ||
pin 4 - speaker | * pin 4 - speaker | ||
pin 5 - speaker | * pin 5 - speaker | ||
pin 6 - microphone (+) | * pin 6 - microphone (+) | ||
pin 7 - DC in | * pin 7 - DC in | ||
pin 8 - bus recv | * pin 8 - bus recv | ||
to connect a non-electronic-hook-switch, only pins 3 to 6 are relevant. | to connect a non-electronic-hook-switch, only pins 3 to 6 are relevant. | ||
[[Category:Faq|{{PAGENAME}}]] | [[Category:Faq|{{PAGENAME}}]] | ||
Revision as of 19:51, 27 June 2007
Here is the pin assignment for the DHSG headset interface. This interface is standardized, so it will be identical for all DHSG phones, not only the IP230. You should be able thus to obtain a proper adapter cable from your headset manufacturer, even if there is not adapter for the IP230 listed.
DHSG uses an 8/8 RJ45 plug.
Assignement:
- pin 1 - bus send
- pin 2 - 0V
- pin 3 - microphone
- pin 4 - speaker
- pin 5 - speaker
- pin 6 - microphone (+)
- pin 7 - DC in
- pin 8 - bus recv
to connect a non-electronic-hook-switch, only pins 3 to 6 are relevant.