Howto:Firmware Upgrade and initial Configuration of IP72 via USB: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
mNo edit summary |
||
| Line 20: | Line 20: | ||
===Configuration=== | ===Configuration=== | ||
To configure IP72 via USB you have to use telnet command line interface. The most commands are the same like on IP110/IP200/IP230 except WLAN configuration commands. | |||
===Known Problems=== | ===Known Problems=== | ||
Sometimes PDM Software or usbload can not find any IP72 Devices allthough this correctly connected. Rebooting PC will help in most cases. | Sometimes PDM Software or usbload can not find any IP72 Devices allthough this correctly connected. Rebooting PC will help in most cases. | ||
Revision as of 12:28, 8 May 2007
This article describes procedure of Firmware upgrade and initial configuration of IP72 via USB interface.
Applies To
This information applies to
- IP72
Ascom Firmware or innovaphone Firmware Build 07-60527 and later.
More Information
Problem Details
System Requirements
- USB-Charger
- USB-Driver for Ascom i75
- Ascom PDM Software in case you have an Ascom i75 phone branded as innovaphone IP72
- usbload tool in case you have IP72 with innovaphone firmware
Installation
At first install USB Driver. Plug USB-Charger to any free USB-Port on your PC and wait till Windows Device Manager ask you for Driver location.
Configuration
To configure IP72 via USB you have to use telnet command line interface. The most commands are the same like on IP110/IP200/IP230 except WLAN configuration commands.
Known Problems
Sometimes PDM Software or usbload can not find any IP72 Devices allthough this correctly connected. Rebooting PC will help in most cases.