Howto:IT - VoipVoice - SIP Trunk SIP-Provider (2018)

List of Issues found in no media-relay Configuration

This is a list of all issues found in a configuration where the media stream between endpoints and the SIP provider - as opposed to the signalling - is not routed through the SBC.

SIP INFO

The provider does not support conveying DTMF using the SIP-INFO method.

Here is the list of test-cases that have been performed for this provider: RALERT_DISC, SUBSCRIBER_NR, 180_RINGING, XFER_BLIND, XFER_CONS_ALERT, XFER_CONS_EXT, XFER_CONS, FAX_T38_ONNET, FAX_T38ANDAUDIO, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, SIP_INFO

List of Issues found in media-relay Configuration

This section lists the results that differ from the results for the first configuration.

The test results for this configuration are the same, however.

Test Results

This section explains the test results for all possible configurations in more detail.

Configuration without media-relay

Registration

The provider supports only UDP as transport protocol. As a result, the SIP-communication is not encrypted(TLS). Moreover it requires all involved network elements to support IP-fragmentation.

NAT Traversal

The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.

DTMF (RFC2833)

The provider can convey DTMF digits using the RTP payload method as per RFC2833. However, DTMF handling overall does not work reliably.

Session Timer

The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.

Redundancy

Registration of two SIP-interfaces on the same SIP-account is not supported by the provider. As a result, you cannot have a Standby gateway/PBX using the same account for failover or load-balancing purposes.

Dialing of Subscriber Numbers

OK

Correct signalling of Ringing-state

OK

Call Transfer

OK

IP-Fragmentation

OK

Large SIP messages

OK

Mobility Calls

Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.

Configuration with media-relay

Registration

The provider supports only UDP as transport protocol. As a result, the SIP-communication is not encrypted(TLS). Moreover it requires all involved network elements to support IP-fragmentation.

NAT Traversal

The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.

DTMF (RFC2833)

The provider can convey DTMF digits using the RTP payload method as per RFC2833. However, DTMF handling overall does not work reliably.

Session Timer

The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.

Redundancy

Registration of two SIP-interfaces on the same SIP-account is not supported by the provider. As a result, you cannot have a Standby gateway/PBX using the same account for failover or load-balancing purposes.

Dialing of Subscriber Numbers

OK

Correct signalling of Ringing-state

OK

Call Transfer

OK

IP-Fragmentation

OK

Large SIP messages

OK

Mobility Calls

Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.

Configuration

Use profile IT-VoipVoice-SIP_Trunk in Gateway/Interfaces/SIP to configure this SIP provider.

Please note the following configuration hints:

• STUN required on all endpoints if media-relay is not used
• 'Set Calling = Diverting No' recommended in PBX 'Trunk' objects

A most recent v12r2 firmware or higher is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2

New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.

Disclaimer

These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.

All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.

If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.

Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.

Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.