Howto:IT - KONVERTO - SIP Trunk SIP-Provider (2024): Difference between revisions

From innovaphone wiki
Jump to navigation Jump to search
Line 1: Line 1:
== Test Results ==
{{SIP_TEST_TESTRESULT_ONLYMR_INTRO}}
=== {{SIP_TEST_RESULTS_MR_TITLE}} ===
; Registration : {{Template:SIP_Profile_Test_Registration_UDP}}
; NAT Traversal : {{Template:SIP_Profile_Test_NAT_a_no_c}}
; DTMF (RFC2833) : {{Template:SIP_Profile_Test_DTMF_RFC2833_yes}}
; Session Timer : {{Template:SIP_Profile_Test_EXPIRES_no}}
; Redundancy : {{Template:SIP_Profile_Test_REDUNDANCY_no}}
; Correct signalling of Ringing-state : {{Template:SIP_Profile_Test_RINGING_no}}
; CLIR : {{Template:SIP_Profile_Test_CLIR_yes}}
; Clip No Screening (CLNS) : {{Template:SIP_Profile_Test_CLNS_no}} {{Template:SIP_Profile_Test_CLNS_no_clns_but_clns_onnet_OK}} {{Template:SIP_Profile_Test_CLNS_no_clns_302_not_recommended}}
; COLP : {{Template:SIP_Profile_Test_COLP_out_yes_in_yes}} {{Template:SIP_Profile_Test_COLP_diff_no}}
; Early-Media : {{Template:SIP_Profile_Test_EARLY_MEDIA_INBOUND_yes}}
; Fax : {{Template:SIP_Profile_Test_AUDIOFAX_PSTN_yes}}
: {{Template:SIP_Profile_Test_T38_PSTN_no_onnet_yes_fallback_no}}
; Codecs : supported to/from PSTN: G711A and G729
: supported onnet (VoIP to VoIP): G711A, G711U and G729
; IP-Fragmentation : {{Template:SIP_Profile_Test_FRAGMENTATION_yes}}
; Large SIP messages : {{Template:SIP_Profile_Test_LARGE_MESSAGES_yes}}
; Reverse Media Negotiation : {{Template:SIP_Profile_Test_REV_MEDIA_NEG_yes}}
; Mobility Calls :  {{Template:SIP_Profile_Test_MobilityCall_no_with_MediaRelay}} {{Template:SIP_Profile_Test_MobilityCall_no_ringing}} {{Template:SIP_Profile_Test_MobilityCall_no_clns_no_history_or_diversion}}
; SRTP : {{Template:SIP_Profile_Test_SRTP_no}}
; Dialing of Subscriber Numbers : {{Template:SIP_Profile_Test_SUBSCRIBER_NR_yes}}
; Call Transfer : {{Template:SIP_Profile_Test_CALL_TRANSFER_ok}}
==Configuration==
==Configuration==
Use profile ''IT-konverto-SIP_Trunk'' in ''Gateway/Interfaces/SIP'' to configure this SIP provider.
Use profile ''IT-konverto-SIP_Trunk'' in ''Gateway/Interfaces/SIP'' to configure this SIP provider.

Revision as of 11:29, 8 April 2024

Configuration

Use profile IT-konverto-SIP_Trunk in Gateway/Interfaces/SIP to configure this SIP provider.

Please note the following configuration hints:

  • Alert not signalled, 'Carrier w/o Alerting' required in all PBX 'Mobility' objects
  • 'Set Calling = Diverting No' recommended in PBX 'Trunk' objects
A most recent v12r2 firmware or higher is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2

New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.

Disclaimer

These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.

All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.

If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.

Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.

Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.