Howto:LU - MIXvoip - SIP Trunk SIP-Provider (2021)

From innovaphone wiki
Revision as of 18:17, 13 January 2017 by Sga (talk | contribs)
Jump to navigation Jump to search

Summary

Tests for the SIP_Trunk SIP trunk product of the provider MIXvoip were completed. Test results have been last updated on January 13th, 2017. Check the history of this article for the date of the first publication of the testreport. <internal>Provider SBC: MIXvoip</internal>


List of Issues found in media-relay Configuration

CLIR
The provider does not fully support suppression of the calling line id (CLIR) using the SIP Privacy: Id header.
CLNS
Outgoing calls cannot be sent with a foreign calling party number (CLI).
FAX T38
The provider does not fully support T.38 fax
FAX T38ANDAUDIO
The provider does not support fallback to audio-fax if T.38 fails.
SIP INFO
The provider does not support conveying DTMF using the SIP-INFO method.

Here is the list of test-cases that have been performed for this provider: 180_RINGING, BASIC_CALL, CLIR, CLNS_ONNET, CLNS, CONN_NR_DIFF, CONN_NR, DTMF, EARLY_MEDIA_INBOUND, FAX_AUDIO, FAX_T38, FAX_T38_ONNET, FAX_T38ANDAUDIO, G711A_ONNET, G711A, G711U_ONNET, G711U, G722_ONNET, G722, G729_ONNET, G729, HOLD_RETRIEVE, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, MOBILITY, OPUS_NB, OPUS_WB, RALERT_DISC, REDIR_302, REDIR_DIVHDR, REDIR_HISTHDR, REVERSE_MEDIA, SIP_INFO, SRTP_INCOMING, SRTP_INTERNAL, SRTP_OUTGOING, XFER_BLIND, XFER_CONS_ALERT, XFER_CONS_EXT, XFER_CONS


Test Results

This SIP provider requires a media-relay configuration. That is, all media traffic between the SIP provider and all endpoints must flow through the SBC. For this reason, a configuration without media-relay has not been tested and hence no test results for this configuration are listed.

Configuration with media-relay

Registration
The provider supports UDP and TCP as transport protocol. The tests were completed using TCP, since UDP is an unreliable protocol and requires all involved network elements to support IP-fragmentation.
NAT Traversal
The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN. However MediaRelay is required, since the provider does not support a change of the remote RTP-endpoint during a call.
DTMF (RFC2833)
The provider does not support conveying telephony events (a.k.a. DTMF) in-band as RTP payload.
Session Timer
The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
Redundancy
Registration of two SIP-interfaces on the same SIP-account is supported by the provider. However, the provider has no failover mechanism if one device is down. As a result, you can use both SIP-interfaces for load-balancing purposes. If one device is down, for 2 minutes incoming and outgoing calls might be rejected/fail.
Correct signalling of Ringing-state
OK
CLIR
CLIR didn't work.
Clip No Screening (CLNS)
CLIP no screening (CLNS) is not possible, that is, outgoing calls can only have the own subscriber number (or extension), no foreign numbers as calling line id. This affects for example externally forwarded and mobility calls. However, on-net (that is, from SIP provider to another customer at the same SIP provider) CLIP no screening (CLNS) is possible. As this is a non-German provider, the issue with off-net CLNS could be related to the provider or related to the international PSTN peering. Please consult the SIP provider if CLNS will work for you. Call redirection using the SIP 302 Redirect header is supported by the provider. Rerouting can be enabled by setting the Reroute supported check-mark in the corresponding Trunk object configuration. Also, the Interworking check-mark must be set in the route used for calls from and to the SIP provider.
However, during our test other interop problems were discovered when the Interworking Flag is enabled. Therefore it is not recommended to use the call redirection via SIP 302 Redirect header.
COLP
Outbound calls to the PSTN show the correct connected number. However incoming calls from the PSTN do not.
A caller from the PSTN will receive an incorrect connected number that differs from the dialled number. This might lead to the caller cancelling the call.
For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
Early-Media
The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
Fax
Transport of faxes to/from the PSTN via G.711 codec was tested successfully. However, all fax endpoints must be configured with exclusive codec "G711A".
Transport of faxes using T.38 worked to onnet destinations. However it failed to PSTN destination and moreover fallback to audiofax failed also.
As a result, T.38 is disabled on the SIP-interface and the use of audio-fax is necessary.
Codecs
supported to/from PSTN: G711A
supported onnet (VoIP to VoIP): G711A
IP-Fragmentation
OK
Large SIP messages
OK
Reverse Media Negotiation
OK
Mobility Calls
Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.
SRTP
The provider does not support audio encryption using SRTP.
Call Transfer
OK


Configuration

Use profile LU-MIXvoip-SIP_Trunk in Gateway/Interfaces/SIP to configure this SIP provider.

A most recent v12r2 firmware or higher is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2

New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.

Disclaimer

These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.

All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.

If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.

Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.

Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.

Retrieved from "https://wiki.innovaphone.com/index.php?title=Howto:LU_-_MIXvoip_-_SIP_Trunk_SIP-Provider_(2021)&oldid=45535"