Reference10:Interfaces/FXO/Physical
Jump to navigation
Jump to search
The physical settings of the analogue FXO interfaces can be made here:
| Receive gain: | Set the loudness a user receives at this interface. Defaults to 0dB, range -6dB to 2.5dB. |
| Transmit gain: | Set the loudness a user transmits at this interface. Defaults to 0dB, range -6dB to 2.5dB. |
| Flashtime: | Define the duration of flash-hook signal generated by the FXO on demand of the voip peer side. Possible values : 100ms, 200ms 300ms, defaults to 300ms. |
| Country: | Set the line impedance for different countries. 'GlobalImpedance' is intended to be used with countries that are not present in the list and that have no known similarities to mentioned countries. |
Explanation of Flash and R
Flash and R is used synonymously. Sometimes hook-flash is also used. Often phones have an R key, but the meaning is all the same.
From a technical point of view Flash is a short interruption in offhook loop-current. You can imagine Flash as a very short hook-on/hook-off event. The on-hook duration of a Flash event is normally between 100ms and 300ms. A Flash on the FXO port will be performed only when the connected voip peer sends a special rtp-dtmf digit code 16d/10h.
The innovaphone FXO ports do NOT support dialing with pulses.
Pinout of the a/b connector
| Pin | Function |
| 3 | TIP |
| 4 | RING |