There are also other versions of this article available: Reference13r1 (this version) | Reference13r2 | Reference13r3 | Reference14r1 | Reference14r2

General

Requirements

SSH-Login with admin and ipapps
root login with root and iplinux (root login is not directly possible over SSH)
web login pwd

The installation image has a size of ~50 MB. During installation, the following partitions are created:
- /dev/sda1 fat32: 200MB (contains ramdisk, rootfs and kernel)
- /dev/sda2 ext4: depends on disk size (contains databases, log files and apps)
- /dev/sda3 ext4: 500MB (contains the rootfs)
- /dev/sda4 swap: 512MB

The default disk size is 16 GB. It should be increased before the first start if needed!

default RAM: 512 MB
static IP address, DNS, gateway can be configured with the command setip on the console. Run setip --help to get a list of parameters.
loadkeys de can be used to change to german keyboard layout (etc.)

partitions:
- /dev/sda1 ext2: 350MB (contains ramdisk, rootfs and kernel)
- /dev/sda2 ext4: depends on disk size (contains databases, log files and apps)
- /dev/sda3 ext4: 500MB (contains the rootfs)
- /dev/sda4 swap: 512MB

If you setup a gateway with the install procedure, the App Platform is installed automatically.

You can also install it manually:

Open App Platform -> General and Enable Linux Support. Restart the gateway.
You need to enable Proxy-ARP on ETH0 or ETH1 here , so your gateway and the linux appliance will share the same physical interface. Simply go to IP4 > ETH0 (if used) > IP and check Proxy ARP.
Open App Platform -> IP and configure the IP settings of the App Platform. Restart the gateway.
Open App Platform -> Installation and select the given version or enter an own path to the app-platform-armel.img image file.
The installation runs without any further required step.