Reference:Configuration/DOOR/Physical: Difference between revisions
Jump to navigation
Jump to search
(goback link removed) |
m (table added) |
||
Line 1: | Line 1: | ||
Here, you can make the settings for the analogue door intercom interface: | Here, you can make the settings for the analogue door intercom interface: | ||
{| | |||
|valign=top nowrap=true|'''WT mode:''' | |||
| This check box should only be checked if compatibility problems occur with certain terminals. | |||
|- | |||
|valign=top nowrap=true|'''Activate relay 2 on CONNECT:''' | |||
| The second relay is closed as standard. If the check box is checked, the second relay is also activated for a CONNECT. | |||
|- | |||
|valign=top nowrap=true|'''Timeout for door opener [0-10 sec]:''' | |||
| Normally, the connection between the DOOR interface and the DI is interrupted only when the 0 key is pressed or the handset is replaced. To avoid the DI being connected with the DOOR interface for a long time, a value (in seconds) can be configured here. The connection is then interrupted after the specified time has elapsed. | |||
|} |
Revision as of 17:51, 13 April 2007
Here, you can make the settings for the analogue door intercom interface:
WT mode: | This check box should only be checked if compatibility problems occur with certain terminals. |
Activate relay 2 on CONNECT: | The second relay is closed as standard. If the check box is checked, the second relay is also activated for a CONNECT. |
Timeout for door opener [0-10 sec]: | Normally, the connection between the DOOR interface and the DI is interrupted only when the 0 key is pressed or the handset is replaced. To avoid the DI being connected with the DOOR interface for a long time, a value (in seconds) can be configured here. The connection is then interrupted after the specified time has elapsed. |