Howto:NIAnet SIP Provider Compatibility Test: Difference between revisions

From innovaphone wiki
Jump to navigation Jump to search
VisualWikitext
m New page: '''Innovaphone Compatibility Test Report''' == Summary == '''SIP Provider: NIAnet''' <!-- The provider supports all required innovaphone features and is therefore qualified as [[Howto:...
 
 
(19 intermediate revisions by the same user not shown)
Line 6: Line 6:
'''SIP Provider: NIAnet'''
'''SIP Provider: NIAnet'''


<!--
The provider does '''not''' support all required innovaphone features and is therefore '''not''' a [[Howto:What_is_a_%22recommended_product%22%3F#SIP_Provider|recommended SIP Provider]].  
The provider supports all required innovaphone features and is therefore qualified as [[Howto:What_is_a_%22recommended_product%22%3F#SIP_Provider|recommended SIP Provider]].  


Toplink does not support the remote hold feature. When making a blind transfer(using redial key) the remote end will not get a MOH/dialtone from the provider.  
NIAnet does not support the DDI feature, by thus making the provider not suited for large installations. As a result, you must configure one SIP trunk for every extension and are limited to 16 SIP - trunks per innovaphone gateway.  


That beeing said, Toplink has achieved 96% of all possible test points. For more information on the test rating, please refer to [[Howto:SIP_Interop_Test_Description#Summary|Test Description]]
That being said, NIAnet has achieved 77% of all possible test points. For more information on the test rating, please refer to [[Howto:SIP_Interop_Test_Description#Summary|Test Description]]




* Features:


** Direct Dial In
* '''Provider Homepage:''' http://www.nianet.dk/
* '''Product name:''' [http://www.nianet.dk/Default.aspx?ID=65 nia-tele]
 
* '''Features:'''
 
** Fax over IP (T.38)
** Fax over IP (T.38)
** DTMF
** DTMF


* Supported Codecs by the provider
* Supported Codecs by the provider
** G711
** G711A
** G729
** G729
** G723
** G726
** T.38 UDP
** T.38 UDP
-->
 
== Current test state ==
== Current test state ==
<!-- {{Template:Compat Status "tested"}}-->
{{Template:Compat Status "tested"}}
{{Template:Compat Status "in progress"}}  
<!-- {{Template:Compat Status "in progress"}} -->
<!-- {{Template:Compat Status "certified"|certificate=Tpl_sip.business_Toplink_SIP_Provider_-_product-cert.pdf}}-->
<!-- {{Template:Compat Status "certified"|certificate=Tpl_sip.business_Toplink_SIP_Provider_-_product-cert.pdf}}-->
<!-- {{Template:Compat Status "rejected"}} -->
<!-- {{Template:Compat Status "rejected"}}-->


<!-- Testing of this product has been finalized August 8th, 2007. -->
Testing of this product has been finalized January 9th, 2009.


== Testing Enviroment ==
== Testing Enviroment ==
Line 72: Line 72:
|----
|----
|Fax using T.38
|Fax using T.38
|?
|Yes
|----
|----
|CGPN can be supressed
|CGPN can be supressed
|Yes
|Yes
|----
|'''Long time call possible(>30 min)'''
|'''Yes'''
|----
|----
|'''Voice Quality OK?'''
|'''Voice Quality OK?'''
Line 114: Line 117:
|----
|----
|'''Call can be put on hold'''  
|'''Call can be put on hold'''  
|'''No. Oneway Audio'''
|'''Yes'''
|----
|----
|Held end hears music on hold / announcement from PBX
|Held end hears music on hold / announcement from PBX
|No
|Yes
|----
|----
|Held end hears music on hold / announcement from provider
|Held end hears music on hold / announcement from provider
Line 154: Line 157:
|'''Call returns to transferring device if the third'''  
|'''Call returns to transferring device if the third'''  
'''Endpoint is not available'''
'''Endpoint is not available'''
|'''?'''
|'''Yes'''
|}
|}


Line 164: Line 167:
|----
|----
|Call can be transfered
|Call can be transfered
|?
|Yes
|----
|----
|Held end hears dialing tone
|Held end hears dialing tone
|?
|Yes
|}
|}


Line 177: Line 180:
|----
|----
|'''Caller can make a call to a Broadcast Group'''
|'''Caller can make a call to a Broadcast Group'''
|'''?'''
|'''Yes'''
|----
|----
|'''Caller can make a call to a Waiting Queue'''
|'''Caller can make a call to a Waiting Queue'''
|'''?'''
|'''Yes'''
|----
|----
|'''Announcement if nobody picks up the call'''
|'''Announcement if nobody picks up the call'''
|'''?'''
|'''Yes'''
|}
|}
<!--
 
== Configuration ==
== Configuration ==


===Firmware version===
===Firmware version===


All innovaphone devices use V6 SR1 HF3 as firmware.
All innovaphone devices use V7 HF1 as firmware.


=== SIP - Trunk ===
=== SIP - Trunk ===


First of all the SIP Trunk must be configured. Here an example of our Toplink - Trunk. If you want that the Gateway should act as Medialrelay, you must exchange the Gatekeeper Address (blue marking) to an private network address (see [[Howto:Toplink_SIP_Compatibility_Test#Media Relay (Scenario 2 only) | Media Relay (Scenario 2 only)]]); for example 127.0.0.1
First of all the SIP Trunk must be configured. Here an example of our NIAnet - Trunk.


 
[[Image:NIAnet SIP Compatibility Test 1.PNG]]
[[Image:Toplink SIP Compatibility Test 1.PNG]]


=== Number Mapping ===
=== Number Mapping ===


The complicated part on this issue is the correct mapping of the outgoing and incoming numbers.  
The complicated part on this issue is the correct mapping of the outgoing and incoming numbers. NIAnet expects the CGPN for outgoing calls to be in national number format.
 
[[Image:Toplink SIP Compatibility Test 2.PNG]]


[[Image:NIAnet SIP Compatibility Test 2.PNG]]


=== Route Settings ===
=== Route Settings ===


Because Toplink, as most SIP - Providers too, doesn't support overlap sending, you must enable the blockwise sending of the phone number. You can do this by enabling ''Force enblock'' in the automatically generated Routes.
Because NIAnet, as most SIP - Providers too, doesn't support overlap sending, you must enable the block wise sending of the phone number. You can do this by enabling ''Force enblock'' in the automatically generated Routes.


The second setting you must check is Interworking(QSIG,SIP). This feature must be enabled to properly relay suplementary services, like Hold over the SIP Trunk. If this checkbox is unchecked only basic call Information like connect and disconnect will be forwarded by the Gateway.
The second setting you must check is Interworking(QSIG,SIP). This feature must be enabled to properly relay supplementary services, like Hold over the SIP Trunk. If this checkbox is unchecked only basic call Information like connect and disconnect will be forwarded by the Gateway.


[[Image:Toplink SIP Compatibility Test 6.PNG]]
[[Image:NIAnet SIP Compatibility Test 3.PNG]]
 
=== Media Relay (Scenario 2 only) ===
 
By enabling Media Relay on the PBX, The IP800 will work as an RTP - Proxy, so all RTP Streams will travel through the IP800. This mode poses a much greater load on the PBX, so the number of concurrent calls will be heavy limited.
 
[[Image:Toplink SIP Compatibility Test 5.PNG]]
 
You may wonder about the usefullness of putting the localhost address as a private network. However you must insert this entry, if the IP800 SIP GW registers at the PBX on localhost interface.


=== Fax ===
=== Fax ===
The FAX was connected via a IP22 to the IP800. When configuring the IP22 you must keep in mind that you will use the analog interface for fax communication. Thats why the T.38 codec must be enabled.
The FAX was connected via a IP22 to the IP800. When configuring the IP22 you must keep in mind that you will use the analog interface for fax communication. Thats why the T.38 codec must be enabled.


 
[[Image:NIAnet SIP Compatibility Test 4.PNG]]
[[Image:Toplink SIP Compatibility Test 3.PNG]]


Now the PBX and the phones are setup correctly. You should be able to make call in both directions and send and receive fax messages.
Now the PBX and the phones are setup correctly. You should be able to make call in both directions and send and receive fax messages.


-->
[[Category:Compat|{{PAGENAME}}]]
[[Category:Compat|{{PAGENAME}}]]

Latest revision as of 16:51, 3 March 2010

Innovaphone Compatibility Test Report


Summary

SIP Provider: NIAnet

The provider does not support all required innovaphone features and is therefore not a recommended SIP Provider.

NIAnet does not support the DDI feature, by thus making the provider not suited for large installations. As a result, you must configure one SIP trunk for every extension and are limited to 16 SIP - trunks per innovaphone gateway.

That being said, NIAnet has achieved 77% of all possible test points. For more information on the test rating, please refer to Test Description


  • Features:
    • Fax over IP (T.38)
    • DTMF
  • Supported Codecs by the provider
    • G711A
    • G729
    • T.38 UDP

Current test state

The tests for this product have been completed.

Testing of this product has been finalized January 9th, 2009.

Testing Enviroment

Scenario NAT

This scenario describes a setup where the PBX and phones are in a private network. The IP800 must use a stun server, in order to send correct SIP - messages. The IP800 works as media relay, all RTP - streams go through the PBX.

Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

Basic Call

Tested feature Result
call using g711a Yes
call using g711u No
call using g723 No
call using g729 Yes
Overlapped sending No
early media channel Yes
Fax using T.38 Yes
CGPN can be supressed Yes
Long time call possible(>30 min) Yes
Voice Quality OK? Yes

Direct Dial In

Tested feature Result
Inbound(Provider -> Innovaphone) No
Outbound(Innovaphone -> Provider) No

DTMF

Tested feature Result
DTMF tones sent correctly Yes
DTMF tones received correctly Yes

Hold/Retrieve

Tested feature Result
Call can be put on hold Yes
Held end hears music on hold / announcement from PBX Yes
Held end hears music on hold / announcement from provider Yes

Transfer with consultation

Tested feature Result
Call can be transfered Yes
Held end hears music on hold Yes
Call returns to transferring device if the third

Endpoint is not available

Yes

Transfer with consultation (alerting only)

Tested feature Result
Call can be transfered Yes
Held end hears music on hold or dialing tone Yes
Call returns to transferring device if the third

Endpoint is not available

Yes

Blind Transfer

Tested feature Result
Call can be transfered Yes
Held end hears dialing tone Yes

Broadcast Group & Waiting Queue

Tested feature Result
Caller can make a call to a Broadcast Group Yes
Caller can make a call to a Waiting Queue Yes
Announcement if nobody picks up the call Yes

Configuration

Firmware version

All innovaphone devices use V7 HF1 as firmware.

SIP - Trunk

First of all the SIP Trunk must be configured. Here an example of our NIAnet - Trunk.

Number Mapping

The complicated part on this issue is the correct mapping of the outgoing and incoming numbers. NIAnet expects the CGPN for outgoing calls to be in national number format.

Route Settings

Because NIAnet, as most SIP - Providers too, doesn't support overlap sending, you must enable the block wise sending of the phone number. You can do this by enabling Force enblock in the automatically generated Routes.

The second setting you must check is Interworking(QSIG,SIP). This feature must be enabled to properly relay supplementary services, like Hold over the SIP Trunk. If this checkbox is unchecked only basic call Information like connect and disconnect will be forwarded by the Gateway.

Fax

The FAX was connected via a IP22 to the IP800. When configuring the IP22 you must keep in mind that you will use the analog interface for fax communication. Thats why the T.38 codec must be enabled.

Now the PBX and the phones are setup correctly. You should be able to make call in both directions and send and receive fax messages.

Retrieved from "https://wiki.innovaphone.com/index.php?title=Howto:NIAnet_SIP_Provider_Compatibility_Test&oldid=16705"