Howto:Analog Trunk (FXO) with Linksys SPA3102: Difference between revisions
Ebc suporte (talk | contribs) |
Ebc suporte (talk | contribs) |
||
Line 68: | Line 68: | ||
Dial Plan 1: (S0<:126@192.168.0.254) | Dial Plan 1: (S0<:126@192.168.0.254) | ||
''In the example 126 is the extension we desire to calls be redirected and 192.168.0.254 the | |||
IPBX IP Address. S0<: means dial in Linksys like a hotline. | IPBX IP Address. S0<: means dial in Linksys like a hotline.'' | ||
Revision as of 19:45, 25 November 2008
Innovaphone Compatibility Test Report
Linksys (Sipura) SPA:3102
Infomation:
- Software Version 3.3.6(GW)
- Hardware version 1.3.5(a)
Information:
- Software Version 5.1.7 (GW)
- Hardware Version 1.4.5 (a)
innovaphone gateway/pbx
This information applies to
- all PBX Platforms
6.00 dvl-sr2 IP800[07-60698]or higher
configuration
With this configuration you can dial the whole number at once . you don´t have to wait for the analog dial tone.
For connecting the Linksys for Analog Trunk ( FXO ) connection to the innovaphone Gateway/pbx you need a Gatekeeper/Registrar license.
V1 In this configuration is created one SIP Trunk Without Registration between Innovaphone Gateway and Linksys SPA3102. Calls are made and receive with Routes.
Linksys configuration
Configuration of the proxy settings
Proxy: Ip address of the innovaphone Gateway/Pbx
user id: the registration name to the innovaphone Gateway/Pbx
Voip to PSTN gateway enable set to yes
Line Voip caller DP set to none
One stage dialing set to no
V1
Login: Admin - Advance Mode
Menu: Voice-> PSTN Line
- Proxy and Registration:
Register:No
Make Call Without Reg:Yes
Ans Call Without Reg:Yes
- Dial Plans:
Dial Plan 1: (S0<:126@192.168.0.254)
In the example 126 is the extension we desire to calls be redirected and 192.168.0.254 the IPBX IP Address. S0<: means dial in Linksys like a hotline.
- VoIP-To-PSTN Gateway Setup:
VoIP-To-PSTN Gateway Enable:Yes
Line 1 VoIP Caller DP:None
PSTN Caller Auth Method:None
One Stage Dialing:No
VoIP Caller Default DP:None
- PSTN-To-VoIP Gateway Setup:
PSTN-To-VoIP Gateway Enable:Yes
PSTN Ring Thru Line 1:No
PSTN CID For VoIP CID:Yes
PSTN Caller Default DP:1
PSTN Caller Auth Method:None
PSTN Caller ID Pattern:*
- FXO Timer Values (sec)
VoIP Answer Delay:0
PSTN Answer Delay:0
innovaphone configuration
Configure a registrar where the Linksys can register (as seen in picture below)
administration/gateway/voip
Configure a route to the Linksys
number out is here a 0 - you can take any digit this is for the analog trunk assignment.
Then you configure a " ^ " this indicates an Delay for one second , then the rest of the number will be dialed in dtmf with 300msec delay between every digit.
For incoming calls (from analog Trunk to innovaphone) you have to configure the proper routes - from the GW where the Sipura is connected to the pbx.
Supported Codecs
Codec | Applies |
---|---|
G711 | yes |
G729 | yes |
G723 | yes |
G726 | yes |
GSM | no |
T.38 UDP | no |
G722 | No |
Test Results
Basic Call
Tested feature | Result |
---|---|
call using g711a | yes |
call using g711u | yes |
call using g723 | yes |
call using g729 | yes |
Overlapped sending | yes |
early media channel | not tested |
Fax | not tested |
Voice Quality OK? | yes |
Dial Inward
Tested feature | Result |
---|---|
Inbound(Sipura -> innovaphone) | yes |
Outbound(Innovaphone -> Sipura) | yes |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | yes |
DTMF tones received correctly (audible) | yes |
Hold/Retrieve
Tested feature | Result |
---|---|
Device can put call on hold | yes |
Held end hears music on hold | yes |
Device can terminate either call and retrieve remaining call | yes |
Transfer with consultation
Tested feature | Result |
---|---|
Device can transfer call | yes |
Held end hears music on hold | yes |
Call returns to transferring device if the third
Endpoint is not available |
yes |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Device can transfer call | yes |
Held end hears music on hold or dialing tone | yes |
Call returns to transferring device if the third
Endpoint is not available |
yes |
Blind Transfer
Tested feature | Result |
---|---|
Device can transfer call | yes |
Held end hears dialing tone | no - hears nothing |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | yes |
Caller can make a call to a Waiting Queue | yes |
Announcement if nobody picks up the call | yes |
Calling Party Number
Tested feature | Result |
---|---|
CGPN is displayed correctly | no |
CGPN can be supressed | yes |