Howto:Skype Connect - SIP Testreport: Difference between revisions
m (→Known Issues) |
m (→Route Settings) |
||
Line 353: | Line 353: | ||
[[Image:Skype_Connect_-_SIP_Testreport_3.png]] | [[Image:Skype_Connect_-_SIP_Testreport_3.png]] | ||
You must set the ''Force enblock'' (b) option on the route for outgoing calls. | |||
=== Known Issues === | === Known Issues === |
Revision as of 10:07, 13 February 2018
Innovaphone Compatibility Test Report
Summary
SIP Provider: Skype
The mandatory feature Early Media is not supported by Skype Connect, the provider never sends any Session Progress message to the PBX before call establishment.
Other found issue was that Skype connect rejects calls with Diverting-info, to overcome this problem we have to enable the option "Set Calling=Diverting No" on the Trunkline object.
- Caller identification using your Skype Number is available in:
- USA
- UK
- Chile
- Denmark
- Estonia
- Hong Kong
- Poland
- Sweden
- As alternative we could verify a landline number using the Verify Procedure of Skype or use a mobile phone as Caller ID. However even these verified numbers are only available for limited countries.
Current test state
The tests for this product could not be completed or not all mandatory tests were passed. See the Summary section for more details.
Testing of this product has been finalized December 20th, 2012.
Testing Enviroment
This scenario describes a setup where the PBX and phones are in a private network.
- the SIP trunk is configured without Media Relay and without exclusive coder.
Test Results
For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.
Basic Call
Tested feature | Result |
---|---|
call using g711a | OK |
call using g711u | OK |
call using g723 | NOK |
call using g729 | OK |
call using g722 | NOK |
Overlapped sending | NOK |
early media channel | NOK, no SDP in 18x messages. |
Fax using T.38 | Not supported as written on product description, not tested |
Reverse Media Negotiation | OK |
CGPN can be suppressed | OK |
CLIP no screening | NOK |
Long time call possible(>30 min) | OK |
External Transfer | OK |
NAT Detection | OK |
Redundancy | Not tested |
SIP over TCP | NOK, no _tcp serv ice record in skype.com domain |
Voice Quality OK? | OK |
Direct Dial In
Tested feature | Result |
---|---|
Inbound(Provider -> Innovaphone via SkypeIn Number) | OK |
Inbound(Provider -> Innovaphone via Skype User) | OK |
Outbound(Innovaphone -> Provider) | OK |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | OK |
DTMF tones sent correctly via SIP-Info | NOK |
DTMF tones received correctly | OK |
Hold/Retrieve
Tested feature | Result |
---|---|
Call can be put on hold | OK |
Held end hears music on hold / announcement from PBX | OK |
Transfer with consultation
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears music on hold | OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK | OK |
inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK | OK |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK | OK |
sip-provider-phone calls inno1. inno1 transfers to inno2. | OK | OK |
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK | OK |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears music on hold or dialling tone | OK |
Call returns to transferring device if the third
Endpoint is not available |
OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK | OK |
inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK | OK |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK | OK |
sip-provider-phone calls inno1. inno1 transfers to inno2. | OK | OK |
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK | OK |
Blind Transfer
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears dialling tone | OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK |
inno1 calls sip-provider-phone. inno1 transfers to inno2. | OK |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK |
sip-provider-phone calls inno1. inno1 transfers to inno2. | OK |
sip-provider-phone calls inno1. sip-provider-phone transfers to inno2. | OK |
CFU/ CFB Transfer
Tested feature | Result |
---|---|
Call can be forward | OK* |
Held end hears dialling tone | OK |
"*" - It's necessary to enable on the Trunkline object the "Set Calling=Diverting No" option. If not the call is rejected by the provider with SIP 403 Forbidden because of it contains Diverting Info.
CFNR/Blind Transfer (alerting only)
Tested feature | Result |
---|---|
Call can be transferred or forward | OK* |
Held end hears dialling tone | OK |
"*" - It's necessary to enable on the Trunkline object the "Set Calling=Diverting No" option. If not the call is rejected by the provider with SIP 403 Forbidden because of it contains Diverting Info.
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to sip-provider-phone. | OK |
inno1 calls sip-provider-phone. sip-provider-phone transfers to inno2. | OK |
sip-provider-phone calls inno1. inno1 transfers to inno2. | OK |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | OK |
Caller can make a call to a Waiting Queue | OK |
Announcement if nobody picks up the call | OK |
Configuration
Firmware version
All innovaphone devices use V9 hf19 as firmware.
SIP - Trunk
Number Mapping
- Skype Caller ID for outgoing calls it's defined on the Skype Manager page that's why we don't define any CGPN Out value.
Route Settings
You must set the Force enblock (b) option on the route for outgoing calls.
Known Issues
It's necessary to enable the Set Calling=Diverting No option on the Trunk Line object. If not, the call is rejected by the provider with SIP 403 Forbidden because of it contains Diverting Info. Diverting info it's always sent even if we don't use the Interwork QSIG/SIG option.