Reference13r1:Apps/PbxManager/Trunks: Difference between revisions
Jump to navigation
Jump to search
| Line 44: | Line 44: | ||
; Interfaces/SBC | ; Interfaces/SBC | ||
: | : Klick (+ Add) to select the target Gateway. | ||
: Klick on the Gateway, you wont to use. | |||
: Chuse if you wont to connect an ISDN-Interface (BRI/PRI/TEL) or an SBC Interface (SIP) to this Trunk. | |||
# Interface | |||
: All possible interfaces where lited. Chuse one, by clicking on them. | |||
: Select a protocoll | |||
- Point to Point (most ISDN with a number area) | |||
- Point to Multipoint (most ISDN with single numbers) | |||
- Manual (Setting was not changed, standart: Point to Multipoint); no wizzard for numbermapping | |||
- After selecting a protocol a wizzard opend to configure the "numbermapping" of the interface. | |||
# SBC (SIP) | |||
== Known issues == | == Known issues == | ||
Revision as of 10:59, 1 July 2024
Configure your Trunklines
Add Trunk
Create a new Trunk object on the PBX
- Name
- The Long Name of the PBX object
- SIP
- The name of the PBX object
- Number
- The number of the object
- Loopback
- target number, when the called number is the trunk-number
- See Trunk specific configurations
- Incomplete
- target number, when the called number is incomplete
- See Trunk specific configurations
- Invalid
- target number, when an incomming call was received
- See Trunk specific configurations
- Busy
- target number, when an incomming call was received with: busy
- See Trunk specific configurations
- Rejected
- target number, when an incomming call was received with: rejected
- See Trunk specific configurations
- No anwser
- target number, when an incomming call was received with: no answer
- See Trunk specific configurations
- Interfaces/SBC
- You have first to create the Trunk and klick OK. Afterwards you can reopen the Trunk configuration and configure the connected Interface/SBC
Edit Trunk
- Interfaces/SBC
- Klick (+ Add) to select the target Gateway.
- Klick on the Gateway, you wont to use.
- Chuse if you wont to connect an ISDN-Interface (BRI/PRI/TEL) or an SBC Interface (SIP) to this Trunk.
- Interface
- All possible interfaces where lited. Chuse one, by clicking on them.
- Select a protocoll
- Point to Point (most ISDN with a number area) - Point to Multipoint (most ISDN with single numbers) - Manual (Setting was not changed, standart: Point to Multipoint); no wizzard for numbermapping - After selecting a protocol a wizzard opend to configure the "numbermapping" of the interface.
- SBC (SIP)
Known issues
- defintion of protocol mode PtP (default PtmP) in PBXManager has no effect to the physical interface settings
- adjustment has to be done via AdvancedUI