Reference:Configuration/DOOR/Physical
Jump to navigation
Jump to search
Here, you can make the settings for the analogue door intercom interface:
- WT mode: This check box should only be checked if compatibility problems occur with certain terminals.
- Activate relay 2 on CONNECT: The second relay is closed as standard. If the check box is checked, the second relay is also activated for a CONNECT.
- Timeout for door opener [0-10 sec]: Normally, the connection between the DOOR interface and the DI is interrupted only when the 0 key is pressed or the handset is replaced. To avoid the DI being connected with the DOOR interface for a long time, a value (in seconds) can be configured here. The connection is then interrupted after the specified time has elapsed.