Reference:Configuration/Registration/Registration
Here, you enter the parameters for registering with the innovaphone PBX. These parameters are preset by the administrator of the telephone system. First, you must select the required protocol for registration. The options are H.323 or SIP. The respective parameters are automatically adjusted to the selected protocol.
H.323 protocol
Primary gatekeeper address
- Here, you specify the IP address at which the first responsible gatekeeper can be reached.
Secondary gatekeeper address
- There should be a further gatekeeper in the network in case the first gatekeeper is unavailable. You enter the IP address of this gatekeeper here.
Local endpoint address
- If several IP addresses are configured on the IP telephone, this setting enables you to specify the IP address to be used for registration with the gatekeeper.
Note: Since the local IP address was preset for the IP telephone using the IP routing table, the value is only necessary in exceptional cases.
Gatekeeper identifier
- If several gatekeepers are to be active at one address, a particular gatekeeper is identified amongst them using the name entered here.
Number
- Here, you specify the call number required for the registration. This number is only required if no name was specified.
Name
- The name you enter here is only required for the registration if the number was not specified.
SIP protocol:
Primary server address
- IP address at which the responsible SIP server may be reached.
Secondary server address
- There should be a further SIP server in the network in case the first one is unavailable.
Local endpoint address
- Defines the local IP address with which the telephone is to register. Is only used in exceptional cases.
Domain
- Instead of the IP address, you can specify the domain of the provider, which is found after the @ of the URI.
User ID
- The user ID, which corresponds to the part in front of the @ of the URI.
Note: The user ID can be numeric or alphanumeric.
STUN server
- The IP address or domain name must be configured if the telephone uses a non-public IP address, but the server is accessible under a public IP address. The value is given by the SIP provider or administrator.
Coder
- The protocols for voice compression are listed in this parameter.
Framesize [ms]
- The packet sizes are automatically negotiated with 60 ms. With this parameter, you can specify a different RTP packet size.
Exclusive
- This parameter allows no negotiation, but accepts only the preset parameters.
Silence compression
- No outbound packets are transmitted from the IP telephone during silence (no conversation).