Howto:List of wildcards
. - '.' at the end of Number In can be used to indicate that the number should match only if the respective number of additional digits is received , stands for a digit , for that will be waited,
Any digits matching with '.' are not replaced by Number Out. This way a conversion of overlap to en-block dialing can be performed
! - '!' at the end of Number In indicates that any additional digit received after it, should be cut off , stands for any lots of digits
? - '?' as digit in Number in indicates that this digit matches to any received digit, stands for any digit without waiting (needed for enum, see also "how to use enum")
^ - '^' character in Number Out indicates that any digit after this character shall be sent as DTMF after the connect.
A - A '!' at the end of Number In indicates that any additional digit received after it, should be cut off