Howto:How to use the IP21 DOOR interface: Difference between revisions
m (→Known Problems) |
m (→Applies To) |
||
| Line 2: | Line 2: | ||
This information applies to | This information applies to | ||
* | *IP21, V4,V5,V6 | ||
Revision as of 16:10, 9 July 2008
Applies To
This information applies to
- IP21, V4,V5,V6
More Information
The door interface of the IP21 is built for connections between door openers.
Some of the door system are outdated and have been replaced with newer models.
Following there is a short compatibility list and some installations tips.
System Requirements
The IP21 DOOR interface supports only Doorline systems:
- Tiptel TSS 2
- Siedle TLM 511
- Siedle LM 511
- Siedle TL 352
- Ritto 5760/…
Installation
In the gateway manual (or see attached ZIP file) you will find a table called pin assignment.
This is the relation between symbolic and real pins
IP21 – backside:
Power – Ethernet – Reset – Tel1 – Tel2 – AUX – DOOR pin 1 … 15
A description of the Door Interface could be found in the schematics called "TFE Aschaltanweisung". This document, describing the wiring of several door interfaces like SIEDLE(TM) and others, could be found on the link below.
Known Problems
The WT mode and non WT mode assignment is different – see schematics or contact support@innovaphone.com therefore.
Doorline Systeme with the standart "FTZ 123 D12" are not supported by IP21 gateway.