Howto:Tracing from Trapeze Access Points to Wireshark: Difference between revisions
Jump to navigation
Jump to search
m (New page: ==Applies To== This information applies to * Trapeze WLAN Infrastucture (e.g. MXR-2) ==Summary== This is a quick a dirty introduction to setting up a Trapeze management switch for traci...) |
m (→Settings) |
||
| Line 8: | Line 8: | ||
==Settings== | ==Settings== | ||
Login to a switch through SSH, here the login transcript: | Login to a Trapeze management switch through SSH, here the login transcript: | ||
login as: admin | login as: admin | ||
Copyright (c) 2002 - 2009 Trapeze Networks, Inc. All rights reserved. | Copyright (c) 2002 - 2009 Trapeze Networks, Inc. All rights reserved. | ||
Username: admin | Username: admin | ||
Password: | Password: | ||
*trapeze-inno> enable | *trapeze-inno> enable | ||
Enter password: | Enter password: | ||
Revision as of 15:56, 4 December 2009
Applies To
This information applies to
- Trapeze WLAN Infrastucture (e.g. MXR-2)
Summary
This is a quick a dirty introduction to setting up a Trapeze management switch for tracing all 802.11 traffic to a Wireshark running on a PC. For complete and official documents, contact http://www.trapezenetworks.com.
Settings
Login to a Trapeze management switch through SSH, here the login transcript:
login as: admin Copyright (c) 2002 - 2009 Trapeze Networks, Inc. All rights reserved. Username: admin Password: *trapeze-inno> enable Enter password: