Howto:Tele2 (Austria) SIP Provider Compatibility Test

From innovaphone wiki
Revision as of 10:29, 1 July 2008 by Tsr (talk | contribs)
Jump to navigation Jump to search

Innovaphone Compatibility Test Report

-- This product is being tested right now. The test is not yet completed. --

Summary

SIP Provider: Tele2(Austria)

  • Features:
    • Direct Dial In
    • Fax over T.38
    • DTMF
  • Supported Codecs by the provider
    • G711
    • G729
    • T.38


Current test state

The tests for this product have been completed. See the Summary section for more details.


Testing Enviroment

Scenario

Scenario NAT

HFO SIP Compatibility Test 5.PNG

This scenario describes a setup where the PBX and phones are in a private network. The IP800 must use a stun server, in order to send correct SIP - messages. The IP800 works as media relay, all RTP - streams go through the PBX.


Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.


Basic Call

Tested feature Result
call using g711a Yes
call using g711u Yes
call using g723 Yes
call using g729 '
Overlapped sending No
early media channel '
Fax using T.38
CGPN can be supressed
Reverse Media Negotiaton '
Voice Quality OK? Yes

Direct Dial In

Tested feature Result
Inbound(Provider -> Innovaphone) Yes
Outbound(Innovaphone -> Provider) Yes

DTMF

Tested feature Result
DTMF tones sent correctly '
DTMF tones received correctly '

Hold/Retrieve

Tested feature Result
Call can be put on hold Yes
Held end hears music on hold / announcement from PBX Yes
Held end hears music on hold / announcement from provider

Transfer with consultation

Tested feature Result
Call can be transfered '
Held end hears music on hold
Call returns to transferring device if the third

Endpoint is not available

'


Transfer with consultation (alerting only)

Tested feature Result
Call can be transfered '
Held end hears music on hold or dialing tone
Call returns to transferring device if the third

Endpoint is not available

'

Blind Transfer

Tested feature Result
Call can be transfered
Held end hears dialing tone

Broadcast Group & Waiting Queue

Tested feature Result
Caller can make a call to a Broadcast Group '
Caller can make a call to a Waiting Queue '
Announcement if nobody picks up the call '

Configuration

General Information

Firmware version


  • IP800: 6.00 sr1-hotfix6 IP800[07-60600.77]
  • IP22: 6.00 sr1-hotfix6 IP22[07-60600.77]
  • IP200: 6.00 sr1-hotfix6 IP230[07-60600.77]
  • IP230: 6.00 sr1-hotfix6 IP230[07-60600.77]

SIP - Trunk

Number Mapping

Route Settings

Fax

Now the PBX and the phones are setup correctly. You should be able to make call in both directions and send and receive fax messages.