Howto:DE - DOKOM - DOKOM21 SIP-Provider 2017: Difference between revisions
(New page: == Summary == {{Template:SIP_TEST_STATUS_ongoing|update=November 27th, 2017|url=|productname=DOKOM21|providername=DOKOM}} === Remarks === * provider does not deliver ''user defined, not s...) |
m (→Remarks) |
||
Line 1: | Line 1: | ||
== Summary == | == Summary == | ||
{{Template:SIP_TEST_STATUS_ongoing|update=November 27th, 2017|url=|productname=DOKOM21|providername=DOKOM}} | {{Template:SIP_TEST_STATUS_ongoing|update=November 27th, 2017|url=|productname=DOKOM21|providername=DOKOM}} | ||
=== Remarks === | <!-- === Remarks === | ||
* provider does not deliver ''user defined, not screened'' calling party number (only ''network defined, screened'') on incoming calls | * provider does not deliver ''user defined, not screened'' calling party number (only ''network defined, screened'') on incoming calls --> | ||
<internal>Provider SBC: Cirpack/v4.76 (gw_sip)</internal> | <internal>Provider SBC: Cirpack/v4.76 (gw_sip)</internal> | ||
=== {{SIP_TEST_ISSUES_NO_MR_TITLE}} === | === {{SIP_TEST_ISSUES_NO_MR_TITLE}} === |
Revision as of 18:57, 28 November 2017
Summary
PRELIMINARY REPORT -- Tests for this product are still ongoing (last updated November 27th, 2017) and may (and probably will) change.
<internal>Provider SBC: Cirpack/v4.76 (gw_sip)</internal>
List of Issues found in no media-relay Configuration
This is a list of all issues found in a configuration where the media stream between endpoints and the SIP provider - as opposed to the signalling - is not routed through the SBC.
- CLNS ONNET
- Onnet-Calls (that is, within the provider's network) do not allow foreign calling party numbers (CGPN). In other words, clip no screening is not possible for on-net calls.
- CLNS
- Outgoing calls cannot be sent with a foreign calling party number (CLI).
- FAX T38 ONNET
- The provider does not support T.38 fax for onnet calls.
- FAX T38
- The provider does not fully support T.38 fax
- Our tests of this feature have shown unstable results (that is, the feature sometimes worked and sometimes did not). This may for example be caused by different equipment used at the provider side (e.g. media gateways) which behave differently.
- FAX T38ANDAUDIO
- The provider does not support fallback to audio-fax if T.38 fails.
- Our tests of this feature have shown unstable results (that is, the feature sometimes worked and sometimes did not). This may for example be caused by different equipment used at the provider side (e.g. media gateways) which behave differently.
- MOBILITY
- The provider can not send DTMF signals via SIP-INFO messages.
- REDIR 302
- The provider does not support external call redirection using the SIP
302 Redirect
response - SDP VIDEO
- The provider does not support receiving video media capabilities in the SDP-part of a SIP message.
- SIP INFO
- The provider does not support conveying DTMF using the SIP-INFO method.
Here is the list of test-cases that have been performed for this provider: 180_RINGING, BASIC_CALL, CLIR, CLNS_ONNET, CLNS, CONN_NR_DIFF, CONN_NR_INCOMING, CONN_NR, DTMF, EARLY_MEDIA_INBOUND, FAX_AUDIO, FAX_T38_ONNET, FAX_T38, FAX_T38ANDAUDIO, G711A_ONNET, G711A, G711U_ONNET, G711U, G722_ONNET, G722, G729_ONNET, G729, HOLD_RETRIEVE, IP_FRAGMENTATION, LARGE_SIP_MESSAGES, MOBILITY, OPUS_NB, OPUS_WB, RALERT_DISC, REDIR_302, REDIR_DIVHDR, REDIR_HISTHDR, REVERSE_MEDIA, SDP_ICE, SDP_RTCP_MUX, SDP_VIDEO, SIP_INFO, SRTP_INCOMING, SRTP_INTERNAL, SRTP_OUTGOING, SUBSCRIBER_NR, XFER_BLIND, XFER_CONS_ALERT, XFER_CONS_EXT, XFER_CONS
List of Issues found in media-relay Configuration
This section lists the results that differ from the results for the first configuration.
- FAX T38 ONNET
- This feature, which does not work in the first configuration, works fine in the second configuration.
- FAX T38
- This feature, which is unstable in the first configuration, works fine in the second configuration.
- FAX T38ANDAUDIO
- This feature, which is unstable in the first configuration, works fine in the second configuration.
- MOBILITY
- This feature, which does not work in the first configuration, works fine in the second configuration.
- REVERSE MEDIA
- The provider does not support reverse media negotiation (a.k.a. late SDP)
- Our tests of this feature have shown unstable results (that is, the feature sometimes worked and sometimes did not). This may for example be caused by different equipment used at the provider side (e.g. media gateways) which behave differently.
- XFER CONS ALERT
- The provider does not fully support consultation call transfer after alert scenarios.
- Our tests of this feature have shown unstable results (that is, the feature sometimes worked and sometimes did not). This may for example be caused by different equipment used at the provider side (e.g. media gateways) which behave differently.
Test Results
This section explains the test results for all possible configurations in more detail.
Configuration without media-relay
- Registration
- The provider supports only UDP as transport protocol. As a result, the SIP-communication is not encrypted(TLS). Moreover it requires all involved network elements to support IP-fragmentation.
- NAT Traversal
- The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN.
- DTMF (RFC2833)
- The provider can convey DTMF digits using the RTP payload method as per RFC2833.
- Session Timer
- The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
- Redundancy
- Registration of two SIP-interfaces on the same SIP-account is not supported by the provider. As a result, you cannot have a Standby gateway/PBX using the same account for failover or load-balancing purposes.
- Correct signalling of Ringing-state
- OK
- CLIR
- OK
- Clip No Screening (CLNS)
- CLIP no screening (CLNS) is not possible, that is, outgoing calls can only have the own subscriber number (or extension), no foreign numbers as calling line id. This affects for example externally forwarded and mobility calls.
- COLP
- Outbound and inbound calls to/from the PSTN show the correct connected number.
- For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
- Early-Media
- The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
- Fax
- Transport of faxes to/from the PSTN via G.711 codec was tested successfully.
- Transport of faxes using T.38 failed to PSTN and onnet destinations. Moreover fallback to audio-fax failed also.
- As a result, T.38 is disabled on the SIP-interface and the use of audio-fax is necessary.
- Codecs
- supported to/from PSTN: G711A
- supported onnet (VoIP to VoIP): G711A
- IP-Fragmentation
- OK
- Large SIP messages
- OK
- Reverse Media Negotiation
- OK
- Mobility Calls
- Transmitting DTMF-tones as SIP-INFO messages is not supported. In a no-media-relay configuration, DTMF signalling can thus not be conveyed to the PBX. Mobility calls will not work.
- SRTP
- The provider does not support audio encryption using SRTP.
- Dialing of Subscriber Numbers
- OK
- Call Transfer
- OK
Configuration with media-relay
- Registration
- The provider supports only UDP as transport protocol. As a result, the SIP-communication is not encrypted(TLS). Moreover it requires all involved network elements to support IP-fragmentation.
- NAT Traversal
- The provider detects clients behind NAT and can handle calls to them without requiring the clients to use NAT-traversal methods like STUN.
- DTMF (RFC2833)
- The provider can convey DTMF digits using the RTP payload method as per RFC2833.
- Session Timer
- The tests regarding the SIP-session timer were successful. This means that either no session expiry is used or that it is used and works. It does not imply that session expiry actually is used.
- Redundancy
- Registration of two SIP-interfaces on the same SIP-account is not supported by the provider. As a result, you cannot have a Standby gateway/PBX using the same account for failover or load-balancing purposes.
- Correct signalling of Ringing-state
- OK
- CLIR
- OK
- Clip No Screening (CLNS)
- CLIP no screening (CLNS) is not possible, that is, outgoing calls can only have the own subscriber number (or extension), no foreign numbers as calling line id. This affects for example externally forwarded and mobility calls.
- COLP
- Outbound and inbound calls to/from the PSTN show the correct connected number.
- For outbound calls to the PSTN, an update of the connected number is not signalled to the caller.
- Early-Media
- The provider supports early-media for outbound calls (hence inbound early media) to the PSTN.
- Fax
- Transport of faxes to/from the PSTN via G.711 codec was tested successfully.
- Codecs
- supported to/from PSTN: G711A
- supported onnet (VoIP to VoIP): G711A
- IP-Fragmentation
- OK
- Large SIP messages
- OK
- Reverse Media Negotiation
- Reverse-media negotiation is not supported. Therefore, a media-relay with exclusive coder configuration will be activated on the SIP-interface.
- Mobility Calls
- Transmitting DTMF-tones as SIP-INFO messages is not supported, however mobility calls are still possible as in the media-relay configuration, the SBC will convey DTMF signalling to the PBX.
- SRTP
- The provider does not support audio encryption using SRTP.
- Dialing of Subscriber Numbers
- OK
- Call Transfer
- The provider does not handle internally transferred-after-alert calls.
Configuration
Use profile DE-DOKOM-DOKOM21 in Gateway/Interfaces/SIP to configure this SIP provider.
- A most recent v12r2 firmware or higher is required to use this SIP-profile. For hints regarding upgrade to v12r2, see Howto:Firmware Upgrade V12r1 V12r2
New profiles are added in the course of our V12R2 software Service Releases, see Support:DVL-Roadmap Firmware 12r2. Here is an up to date list of tested SIP providers.
Disclaimer
These tests look at a number of interoperability scenarios between innovaphone SIP devices and a given SIP trunk product. As we are enhancing our testing procedures, nature and number of these tests will vary.
All test results document the fact how the tested combination performs in the tested scenario. It explicitly does not comment on the question what the reason is for the behaviour nor if and how it could be changed. It thus does not imply that either the SIP trunk provider or the innovaphone device fails in any way. It merely says that the combination does not perform as defined by the test.
If not mentioned otherwise, all tests are repeated on a weekly basis (a.k.a. nightly tests) using the then-current innovaphone firmware. If a tested combination keeps performing differently from the state documented here during nightly tests, we reserve the right to update this article accordingly.
Some tests do not have consistent results. This may occur for various reasons. If so, we document the tests result as being unstable.
Some of the tested SIP trunk products are not available for nightly tests. In this case, the fact will be noted in the Summary section.