Howto:UPC Cablecom Provider Compatibility Test

FIXME: Note: Article - Name should be Howto:Productname-SIP-provider-compatibility-test. It is important that the productname is in the article title and not the provider name or country-a provider could have different products or the same product in more countries

Innovaphone Compatibility Test Report

Summary

SIP Provider: UPC Cablecom

The provider supports all required innovaphone features and is therefore qualified as recommended SIP Provider.

...

That being said, the provider has achieved x% of all possible test points. For more information on the test rating, please refer to Test Description

• Features:

• • Direct Dial In
  • Fax over IP (T.38)
  • DTMF

• Supported Codecs by the provider
  • G711
  • G729
  • G723
  • G726
  • T.38 UDP

Current test state

<internal> Beim Abschluss des Tests (egal ob gut, schlecht oder abgebrochen) bitte Nachricht an ckl! </internal>

Testing Enviroment

This scenario describes a setup where the PBX and phones are in a private network.

There are 3 major configuration variants of the SIP trunk, which one is used depends on the test results. The variants are:

• the SIP trunk is configured without Media Relay and without exclusive coder. This is the case if all tests were successful
• the SIP trunk is configured with Media Relay and STUN but without exclusive coder. This is the case when the test for "NAT Traversal" fails
• the SIP trunk is configured with Media Relay and exclusive coder. This is the case when the test for "Reverse Media Negotiation" fails

The test scenario should describe which SIP trunk configuration is needed.

Test Results

For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.

FIXME: Note: Possible test results are Ok, Nok, Not tested, N/A(not available). Ok, Nok, N/A are self explanatory. "Not tested" is more a temporary note - if its still in the test after finishing, then the summary should explain why the feature was not tested. Remove this note in the final report

Basic Call

Tested feature	Result
call using g711a
call using g711u
call using g723
call using g729
call using g722
Overlapped sending
early media channel
Fax using T.38
T.38 Transcoding by the provider
Reverse Media Negotiation
CGPN can be suppressed
CLIP no screening
Long time call possible(>30 min)
External Transfer
NAT Detection
Redundancy
SIP over TCP
Voice Quality OK?

Direct Dial In

Tested feature	Result
Inbound(Provider -> Innovaphone)
Outbound(Innovaphone -> Provider)
Loop In call(Innovaphone -> Provider -> Innovaphone)

DTMF

Tested feature	Result
DTMF tones sent correctly
DTMF tones sent correctly via SIP-Info
DTMF tones received correctly

Hold/Retrieve

Tested feature	Result
Call can be put on hold
Held end hears music on hold / announcement from PBX

Transfer with consultation

Tested feature	Result
Call can be transferred
Held end hears music on hold

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?	MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.
inno1 calls PSTN-phone. inno1 transfers to inno2.
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to inno2.
PSTN-phone calls inno1. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.

Transfer with consultation (alerting only)

Tested feature	Result
Call can be transferred
Held end hears music on hold or dialling tone
Call returns to transferring device if the third Endpoint is not available

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?	MoH Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.
inno1 calls PSTN-phone. inno1 transfers to inno2.
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to inno2.
PSTN-phone calls inno1. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.

Blind Transfer

Tested feature	Result
Call can be transferred
Held end hears dialling tone

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.
inno1 calls PSTN-phone. inno1 transfers to inno2.
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to inno2.
PSTN-phone calls inno1. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.

CFU / CFB Transfer

Tested feature	Result
Call can be forward
Held end hears dialling tone

CFNR / Blind Transfer (alerting only)

Tested feature	Result
Call can be transferred or forward
Held end hears dialling tone

The following tests are made to test if call transfer is working.

Tested feature	Voice Ok?
inno1 calls inno2. inno2 transfers to PSTN-phone.
inno1 calls PSTN-phone. PSTN-phone transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to inno2.
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2.

Broadcast Group & Waiting Queue

Tested feature	Result
Caller can make a call to a Broadcast Group
Caller can make a call to a Waiting Queue
Announcement if nobody picks up the call

Configuration

Firmware version

All innovaphone devices use Vx build xx-xxxxx as firmware.