Reference:Configuration/DECT/Master

Note: This information applies to IP1200

It is necessary to configure the operating mode of the DECT system. A gatekeeper must also be specified here, on which the innovaphone PBX component is operated.

• Mode: Active switches on the DECT master function. In every DECT system, there must be a DECT master.
  • Off switches off the DECT master function.
  • Active switches on the DECT master function.
  • Standby switches on the standby function for the DECT master.
• Primary Master IP Address: This field is only visible if this device has been configured as Standby-Master (Mode = Standby). The IP address of the DECT-Master has to be configured here.
• GK: The IP address of the primary gatekeeper. The device on which the innovaphone PBX component is operated.
• Alt GK: The IP address of the secondary, alternative gatekeeper.
• GK ID: The gatekeeper ID of the gatekeeper to be used. It is required to configure a gatekeeper ID if in the DECT Master device a PBX is also active.
• Prot: The protocol to be used for the communication. There is a choice between:
  • H.323 (RFC 1889), which is the recommended protocol for innovaphone VoIP devices, since it implements most features.
  • SIP (RFC 3261).
• STUN Server: STUN server to be used if DECT master has no public ip address and SIP server is outside the local network.
• Name for Authentication: Some SIP PBXs need authentication name different from the registration id. This enables the number being used as id and the name for authentication.
• Redirection with GK ID If enabled and the user registration is redirected, the GK ID of the redirecting PBX is appended to the registration to the redirected PBX.
• Enbloc Dialing If enabled, the dialed numbers will be sent together within the setup message after timeout.
• Allow DTMF through RTP If enabled, DTMF capability through RTP is allowed.
• Enable messaging to PBX Message will be send via SIP or H.323, if disabled messages will be sent via the Polycom MSF-Module.
• Idle Display Update Enables idle display updates.
• Disable broadcast delay For small installations it is not necessary to delay the broadcasts for incoming calls to the radios. Enabling this option is not recommended for big systems.