Howto:IP62 WLAN WiFi Handset - innovaphone - H323 Testreport: Difference between revisions
Jump to navigation
Jump to search
m (→Device Setup) |
m (→Device Setup) |
||
Line 90: | Line 90: | ||
|---- | |---- | ||
|Device can configure IP address, GK attributes (gk-id, gk-ip, alias) from DHCP (vendor specific) | |Device can configure IP address, GK attributes (gk-id, gk-ip, alias) from DHCP (vendor specific) | ||
|No | |No. Only domain name. 1stGK, 2ndGK, GK-Identifier where still empty. Codec must be set fix with WinPdm. | ||
|---- | |---- | ||
|Device refreshes the PBX registration | |Device refreshes the PBX registration |
Revision as of 11:10, 28 August 2012
This product is being tested right now. The test is not yet completed.
Summary
Certification Status
Version
Firmware Version:
3.4.6
Hardware Version:
IP62 HW Type:902202, HW rev: G5, Production date:12w12
innovaphone Firmware:
V9 Hotfix 15
Device Setup
Tested feature | Result |
---|---|
Register Device w/o specific configuration (requires DHCP, GK detection and “magic” alias) | No, WinPDM is needed |
DHCP is default | Ok |
DHCP yields timeserver and time displays correctly | Takes number of PBX if no fixed NTP-IP is configured |
SNTP config has TZ string for timezone/dst autoconfig | config via WinPDM |
DHCP yields correct default gateway | Yes |
Device supports magic registration (e.g. by serial) | No? |
GK discovery works | No. Numbers must configured in WinPDM and associate to devices. Generell settings as language, Network, GK-ID-IP cann deployed with templates, but device must fit in the (programmable)charger |
Fixed GK registrations works | Yes, with IP |
2nd GK is supported | Yes |
Changing registrations between GK1 and GK2 | Yes |
Registrations supports GK-ID | Yes and No. You can set GK-ID but need the IP, too. |
Device registers w/o Extension (just by name) | No. Number is needed, too. Hardware-ID in User-Object must be the name |
Device registers by name with non-latin1 characters (e.g. UserÄÖÜ) | Yes |
Device registers by extension | Yes |
Device registers with H.235 password | Yes, but it's confusing in WinPDM. UserObject passwd can found in WinPDM in field gatekeeper passwd. |
Device registers multiple identities | No, not within the phone. It's possible to add identities in WinPDM and associate and change them to a phone (reboot after sync. required) |
Device sends NAT - keepalive messages | |
PBX redirect (UserObject on Master/Phone at Slave registered) | Yes |
Physical Location (@PBX) correct? | Yes |
Device can configure IP address, GK attributes (gk-id, gk-ip, alias) from DHCP (vendor specific) | No. Only domain name. 1stGK, 2ndGK, GK-Identifier where still empty. Codec must be set fix with WinPdm. |
Device refreshes the PBX registration | |
Device supports SRTP | |
Device supports HTTPS | |
Device supports VAD (Voice activity detection) | |
Supported menu languages |
Test Results
Basic Call
Tested feature | Result |
---|---|
call using g711a | yes |
call using g711u | yes |
call using g729 | yes |
call using g722 | yes |
Overlapped sending | yes |
Early media channel | |
Device shows called id number | yes, if Name is not known or is not saved in contacts. Otherwise only name is displayed |
Device shows called id name | yes |
Device shows called id display info | Display Name is shown for less then 0,3 sec., then Name is shown (not Long Name) |
CGPN can be supressed | No |
Reverse Media Negotiaton | |
Device shows CDPN/CGPN on incoming call | NO! Internal calls=ObjectName and for external calls -extern- is displayed. But number is saved in call list (if editing the call) |
Device shows CDPN/CGPN on outgoing call | NO! Internal calls=ObjectName and for external calls -extern- is displayed. But number is saved in call list (if editing the call) |
Device shows connected number | No |
Device shows diverting number | No number. Shows only -redirecting- if call from CFU comes is. If CFU on IP62 is conifgured target number is displayed |
Device supports distinctive ringing | Yes |
Device supports asymetric codec negotiation | |
Device supports codec renegotiation during a conversation | Yes |
Device shows correct display message in case of busy CDPN | Yes |
Device shows correct display message in case of not existing CDPN | Yes. -Invalid number- if number doesn't exist or -no response- if number exist but i.e. is not registered |
Device shows correct display message in case that the call is declined | Yes. Inclusive call back request. |
SOAP Call works? | |
Device supports display updates during call(needed for Directory Search object) | |
Long Time Call (>30 min) works? | |
Registration redirecting works? | |
Incoming SRTP call - SRTP not enabled on DUT | Yes |
Incoming SRTP call - SRTP enabled on DUT | |
Voice Quality OK? |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | |
DTMF tones received correctly |
Hold/Retrieve
Tested feature | Result |
---|---|
Device handles incoming hold correctly | |
Device can put a call on hold using correctly |
Transfer with consultation
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to testphone. | ||
inno1 calls inno2. inno1 transfers to testphone. | ||
inno1 calls testphone. inno1 transfers to inno2. | ||
inno1 calls testphone. testphone transfers to inno2. | ||
testphone calls inno1. inno1 transfers to inno2. | ||
testphone calls inno1. testphone transfers to inno2. |
Transfer with consultation (alerting only)
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to testphone. | ||
inno1 calls inno2. inno1 transfers to testphone. | ||
inno1 calls testphone. inno1 transfers to inno2. | ||
inno1 calls testphone. testphone transfers to inno2. | ||
testphone calls inno1. inno1 transfers to inno2. | ||
testphone calls inno1. testphone transfers to inno2. |
Blind Transfer
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to testphone. | |
inno1 calls inno2. inno1 transfers to testphone. | |
inno1 calls testphone. inno1 transfers to inno2. | |
inno1 calls testphone. testphone transfers to inno2. | |
testphone calls inno1. inno1 transfers to inno2. | |
testphone calls inno1. testphone transfers to inno2. |
Blind Transfer (alerting only)
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to testphone. | |
inno1 calls testphone. testphone transfers to inno2. | |
testphone calls inno1. inno1 transfers to inno2. |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
testphone makes call to a Broadcast Group. inno1 picks up. | |
inno1 makes call to a Broadcast Group. testphone picks up. | |
testphone makes call to a Waiting Queue. inno1 picks up before announcement is played. | |
testphone makes call to a Waiting Queue. inno1 picks up after announcement is played. | |
inno1 makes call to a Waiting Queue. testphone picks up. |
DTMF Features
Tested feature | Result |
---|---|
CFU Activate/Deactivate | |
CFB Activate/Deactivate | |
CFNR Activate/Deactivate | |
Pickup Group | |
Pickup Directed | |
Park/Unpark | |
Park To/Unpark From | |
Call Completion Busy | |
Call Completion Cancel | |
Join Group/Leave Group | |
Join All Groups/Leave All Groups | |
Enable mobility/Disable mobility | |
Enable mobility cw/Disable mobility cw | |
Set presence |
Other Features
Directory
Tested feature | Result |
---|---|
Device built-in directory exists | |
Can be dialled from | |
Does CLI resolution | |
display update if directory object is used? |
Tested feature | Result |
---|---|
External LDAP Server supported | |
Can be dialled from | |
Does CLI resolution | |
display update if directory object is used? |
Keys
Tested feature | Result |
---|---|
Device has speed dial keys | |
Device has programmable function keys | |
Device has partner keys |