Howto:IP62 WLAN WiFi Handset - innovaphone - H323 Testreport: Difference between revisions
Jump to navigation
Jump to search
Line 147: | Line 147: | ||
|---- | |---- | ||
|Reverse Media Negotiaton | |Reverse Media Negotiaton | ||
| | |Yes | ||
|---- | |---- | ||
|Device shows CDPN/CGPN on incoming call | |Device shows CDPN/CGPN on incoming call |
Revision as of 16:08, 4 September 2012
This product is being tested right now. The test is not yet completed.
Summary
Certification Status
Version
Firmware Version:
IP62 3.4.6
Hardware Version:
IP62 HW Type:902202, HW rev: G5, Production date:12w12
innovaphone Firmware:
V9 Hotfix 15
Device Setup
Tested feature | Result |
---|---|
Register Device w/o specific configuration (requires DHCP, GK detection and “magic” alias) | No, WinPDM is needed |
DHCP is default | Ok |
DHCP yields timeserver and time displays correctly | Takes Time from PBX if no fixed NTP-IP is configured |
SNTP config has TZ string for timezone/dst autoconfig | Yes. Different Time Zones are choosable |
DHCP yields correct default gateway | Yes |
Device supports magic registration (e.g. by serial) | No? |
GK discovery works | No. Numbers must configured in WinPDM and associate to devices. Generell settings as language, Network, GK-ID-IP cann deployed with templates, but device must fit in the (programmable)charger |
Fixed GK registrations works | Yes, with IP |
2nd GK is supported | Yes |
Changing registrations between GK1 and GK2 | Yes |
Registrations supports GK-ID | Yes and No. You can set GK-ID but need the IP, too. |
Device registers w/o Extension (just by name) | No. Number is needed, too. Hardware-ID in User-Object must be the name |
Device registers by name with non-latin1 characters (e.g. UserÄÖÜ) | Yes |
Device registers by extension | Yes |
Device registers with H.235 password | Yes, but it's confusing in WinPDM. UserObject passwd can found in WinPDM in field gatekeeper passwd. |
Device registers multiple identities | No, not within the phone. It's possible to add identities in WinPDM and associate and change them to a phone (reboot after sync. required) |
Device sends NAT - keepalive messages | Yes |
PBX redirect (UserObject on Master/Phone at Slave registered) | Yes |
Physical Location (@PBX) correct? | Yes |
Device can configure IP address, GK attributes (gk-id, gk-ip, alias) from DHCP (vendor specific) | No. Only domain name. 1stGK, 2ndGK, GK-Identifier where still empty. Codec must be set fix with WinPdm. |
Device refreshes the PBX registration | Yes |
Device supports SRTP | No |
Device supports HTTPS | No |
Device supports VAD (Voice activity detection) | No |
Supported menu languages | 18 languages |
Test Results
Basic Call
Tested feature | Result |
---|---|
call using g711a | yes |
call using g711u | yes |
call using g729 | yes |
call using g722 | yes |
Overlapped sending | yes |
Early media channel | yes |
Device shows called id number | yes, if Name is not known or is not saved in contacts. Otherwise only name is displayed |
Device shows called id name | yes |
Device shows called id display info | Display Name is shown for less then 0,3 sec., then Name is shown (not Long Name) |
CGPN can be supressed | No |
Reverse Media Negotiaton | Yes |
Device shows CDPN/CGPN on incoming call | NO! Internal calls=ObjectName and for external calls -extern- is displayed. But number is saved in call list (if editing the call) |
Device shows CDPN/CGPN on outgoing call | NO! Internal calls=ObjectName and for external calls -extern- is displayed. But number is saved in call list (if editing the call) |
Device shows connected number | No |
Device shows diverting number | No number. Shows only -redirecting- if call from CFU comes in. If CFU on IP62 is conifgured target number is displayed |
Device supports distinctive ringing | Yes |
Device supports asymetric codec negotiation | n.a. |
Device supports codec renegotiation during a conversation | Yes |
Device shows correct display message in case of busy CDPN | Yes |
Device shows correct display message in case of not existing CDPN | Yes. -Invalid number- if number doesn't exist or -no response- if number exist but i.e. is not registered |
Device shows correct display message in case that the call is declined | Yes. Inclusive call back request. |
SOAP Call works? | |
Device supports display updates during call(needed for Directory Search object) | Yes |
Long Time Call (>30 min) works? | yes. 45 min. tested. |
Registration redirecting works? | Yes |
Incoming SRTP call - SRTP not enabled on DUT | Yes |
Incoming SRTP call - SRTP enabled on DUT | Not possible to enable |
Voice Quality OK? | permanent background noise |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | yes |
DTMF tones received correctly | Yes (RFC 2833 RTP Event) |
Hold/Retrieve
Tested feature | Result |
---|---|
Device handles incoming hold correctly | Only if U-APSD is disabled MOH is hearable without cuts. #86366 |
Device can put a call on hold using correctly | Yes |
Transfer with consultation
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to testphone. | Yes | Yes |
inno1 calls inno2. inno1 transfers to testphone. | Yes | Yes |
inno1 calls testphone. inno1 transfers to inno2. | Yes | Yes, if U-APSD is disabled MOH is hearable without cuts. |
inno1 calls testphone. testphone transfers to inno2. | Yes | Yes |
testphone calls inno1. inno1 transfers to inno2. | Yes | Yes |
testphone calls inno1. testphone transfers to inno2. | Yes | Yes |
Transfer with consultation (alerting only)
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to testphone. | Yes | Yes |
inno1 calls inno2. inno1 transfers to testphone. | Yes | Yes |
inno1 calls testphone. inno1 transfers to inno2. | Yes | If U-APSD is disabled MOH and Ringback is hearable without cuts. |
inno1 calls testphone. testphone transfers to inno2. | No. Transfer with consultation must be connected to transfer. | Yes |
testphone calls inno1. inno1 transfers to inno2. | Yes | If U-APSD is disabled MOH and Ringback is hearable without cuts. |
testphone calls inno1. testphone transfers to inno2. | No. Transfer with consultation must be connected to transfer. | Yes |
Blind Transfer
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to testphone. | Yes |
inno1 calls inno2. inno1 transfers to testphone. | Yes |
inno1 calls testphone. inno1 transfers to inno2. | Yes |
inno1 calls testphone. testphone transfers to inno2. | Yes |
testphone calls inno1. inno1 transfers to inno2. | Yes |
testphone calls inno1. testphone transfers to inno2. | Yes |
Blind Transfer (alerting only)
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to testphone. | Yes |
inno1 calls testphone. testphone transfers to inno2. | No. Call must be established to transfer |
testphone calls inno1. inno1 transfers to inno2. | No ringback tone hearable on IP62 after inno1 blindtransfer to inno2 (#86202) |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
testphone makes call to a Broadcast Group. inno1 picks up. | Yes |
inno1 makes call to a Broadcast Group. testphone picks up. | Yes |
testphone makes call to a Waiting Queue. inno1 picks up before announcement is played. | Yes |
testphone makes call to a Waiting Queue. inno1 picks up after announcement is played. | Yes |
inno1 makes call to a Waiting Queue. testphone picks up. | Yes |
DTMF Features
Tested feature | Result |
---|---|
CFU Activate/Deactivate | Yes |
CFB Activate/Deactivate | Yes, but no icon/info for enabled CFB |
CFNR Activate/Deactivate | Yes, but no icon/info for enabled CFB |
Pickup Group | Yes, but no pickup-key and/or Display Info for incomming call |
Pickup Directed | Yes, but no pickup-key and/or Display Info for incomming call |
Park/Unpark | Yes |
Park To/Unpark From | Yes |
Call Completion Busy | Yes. But with *37*$# the call back number is not shown. Instead you see on IP62 Display "Extern". You can use instead the call-back function from IP62 (shows correct name) |
Call Completion Cancel | Yes |
Join Group/Leave Group | Yes |
Join All Groups/Leave All Groups | Yes |
Enable mobility/Disable mobility | Yes |
Enable mobility cw/Disable mobility cw | Yes |
Set presence | Yes. Our phones can see the presence state of IP62. But, IP62 can't see presence state of our phones. |
Other Features
Directory
Tested feature | Result |
---|---|
Device built-in directory exists | Yes |
Can be dialled from | Yes |
Does CLI resolution | Yes |
display update if directory object is used? | Yes |
Tested feature | Result |
---|---|
External LDAP Server supported | No |
Can be dialled from | No |
Does CLI resolution | No |
display update if directory object is used? | No |
Keys
Tested feature | Result |
---|---|
Device has speed dial keys | Yes |
Device has programmable function keys | Yes |
Device has partner keys | No |