Howto:GlobalConnect SIP-Trunk - SIP Provider Compatibility Test: Difference between revisions
No edit summary |
m (→Test Results) |
||
Line 59: | Line 59: | ||
|---- | |---- | ||
|call using g723 | |call using g723 | ||
| | |Ok, if remote end is at same provider and also supports G723 | ||
|---- | |---- | ||
|call using g729 | |call using g729 | ||
Line 86: | Line 86: | ||
|---- | |---- | ||
|CLIP no screening | |CLIP no screening | ||
| | |Ok | ||
|---- | |---- | ||
|'''Long time call possible(>30 min)''' | |'''Long time call possible(>30 min)''' |
Revision as of 11:02, 22 August 2014
Innovaphone Compatibility Test Report
Summary
GlobalConnect
The provider does not support all required innovaphone features and is therefore not qualified as recommended SIP Provider.
The main reason for not passing the test is the missing ring tone when external calls(PSTN) are forwarded back to the PSTN. Additionally the provider doesn't support CLIR, ClipNoScreening and Redundancy scenarios with multiple SIP-trunks(master & standby) registered at one account.
For more information on the test rating, please refer to Test Description
- Features:
- DTMF
- Supported Codecs by the provider
- G711
- G729
- T.38
Current test state
The tests for this product could not be completed or not all mandatory tests were passed. See the Summary section for more details.
Testing of this product has been finalized August 1st, 2014.
Testing Enviroment
This scenario describes a setup where the PBX and phones are in a private network.
The SIP trunk is configured without Media Relay and without exclusive coder.
Test Results
For more information on the test procedure, please read the following wiki article: SIP Interop Test Description. Bold lines in the test results indicate a KO-criteria.
Basic Call
Tested feature | Result |
---|---|
call using g711a | Ok |
call using g711u | Ok |
call using g723 | Ok, if remote end is at same provider and also supports G723 |
call using g729 | Ok |
call using g722 | Ok, if remote end is at same provider and also supports G722 |
Overlapped sending | Nok |
early media channel | Ok |
Fax using T.38 | Ok |
T.38 Transcoding by the provider | Nok |
Reverse Media Negotiation | Ok |
CGPN can be suppressed | Nok |
CLIP no screening | Ok |
Long time call possible(>30 min) | Ok |
External Transfer | Ok |
NAT Detection | Ok |
Redundancy | Nok |
SIP over TCP | Nok |
Voice Quality OK? | Ok |
Direct Dial In
Tested feature | Result |
---|---|
Inbound(Provider -> Innovaphone) | Ok |
Outbound(Innovaphone -> Provider) | Ok |
Loop In call(Innovaphone -> Provider -> Innovaphone) | Ok |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly | Ok |
DTMF tones sent correctly via SIP-Info | Nok |
DTMF tones received correctly | Ok |
Hold/Retrieve
Tested feature | Result |
---|---|
Call can be put on hold | Ok |
Held end hears music on hold / announcement from PBX | Ok |
Transfer with consultation
Tested feature | Result |
---|---|
Call can be transferred | Ok |
Held end hears music on hold | Ok |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | Ok | Ok |
inno1 calls PSTN-phone. inno1 transfers to inno2. | Ok | Ok |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. inno1 transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | Ok | Ok |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Call can be transferred | Ok |
Held end hears music on hold or dialling tone | Ok |
Call returns to transferring device if the third
Endpoint is not available |
Ok |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | Ok | Ok |
inno1 calls PSTN-phone. inno1 transfers to inno2. | Ok | Ok |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. inno1 transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | Ok | Ok |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | Ok | Ok |
Blind Transfer
Tested feature | Result |
---|---|
Call can be transferred | Ok |
Held end hears dialling tone | Ok |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | Ok |
inno1 calls PSTN-phone. inno1 transfers to inno2. | Ok |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | Ok |
PSTN-phone calls inno1. inno1 transfers to inno2. | Ok |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | Ok |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | Ok |
CFU / CFB Transfer
Tested feature | Result |
---|---|
Call can be forwarded | Ok |
Held end hears dialling tone | Nok |
CFNR / Blind Transfer (alerting only)
Tested feature | Result |
---|---|
Call can be transferred or forwarded | Ok |
Held end hears dialling tone | Ok |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | Ok |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | Ok |
PSTN-phone calls inno1. inno1 transfers to inno2. | Ok |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | Ok |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | Ok |
Caller can make a call to a Waiting Queue | Ok |
Announcement if nobody picks up the call | Ok |
Configuration
Firmware version
All innovaphone devices use V10 SR12 as firmware.