Howto:Sunrise Business voice - SIP Trunk - SIP Provider Compatibility Test: Difference between revisions
Line 22: | Line 22: | ||
'''Sunrise doesn't support "Reverse Media negotiation". Because of this, "Media-Relay" and an "Exclusive Coder Setting" must be configured.''' In contrast to a SIP trunk which does not need Media-Relay, the transport of all RTP packets across the gateway will result in a higher CPU load. | '''Sunrise doesn't support "Reverse Media negotiation". Because of this, "Media-Relay" and an "Exclusive Coder Setting" must be configured.''' In contrast to a SIP trunk which does not need Media-Relay, the transport of all RTP packets across the gateway will result in a higher CPU load. | ||
In order to use some Features like[[Howto:How_does_CLIP_no_screening_work | Clip no screening]], some [[Howto: | In order to use some Features like[[Howto:How_does_CLIP_no_screening_work | Clip no screening]], some [[Howto:Sunrise_Business_voice_-_SIP_Trunk_-_SIP_Provider_Compatibility_Test#Configuration|configuration]] must be done. | ||
Supported Features: | Supported Features: |
Revision as of 13:37, 3 July 2015
Innovaphone Compatibility Test Report
Summary
SIP Provider: Sunrise Business voice
The provider supports all mandatory innovaphone features and is therefore qualified as recommended SIP Provider.
That being said, the provider has achieved 86,34% of all possible test points (139 of 161). For more information on the test rating, please refer to Test Description V11 and later
Please Note, that some features are restricted or not supported by Sunrise
- The T.38 feature is not available
- Fax via G.711 (T.38 to G.711 / Audio Fax support) is supported by Sunrise and work in most scenarios.
- Only G.711a, G.711u is supported, in special cases G.729 is supported, no other codecs are supported
- Overlapped Sending is not supported
- NAT Detection is not supported
- Redundancy Mechanism are supported when using two Sunrise Gateways
- SIP over TCP and SIP over TLS is not supported
- Call using STP are not supported
Sunrise doesn't support "Reverse Media negotiation". Because of this, "Media-Relay" and an "Exclusive Coder Setting" must be configured. In contrast to a SIP trunk which does not need Media-Relay, the transport of all RTP packets across the gateway will result in a higher CPU load.
In order to use some Features like Clip no screening, some configuration must be done.
Supported Features:
- Direct Dial In
- DTMF
- CGPN can be suppressed
- CLIP No Screening
- Hold/Retrieve
- Blind Transfer
Supported Codecs:
- G.711a, G.711u and in special cases G.729 only
Current test state
This product is being tested right now. The test is not yet completed.
Testing of this product has been finalized July 2015.
Testing Enviroment
This scenario describes a setup where the PBX and phones are in a private network.
Sunrise is providing an own Gateway ("SBC") which must be located in the customers private network. This Gateway has two connections:
- One connection to Sunrise
- One connection to the PBX
Because of this, the SIP Trunk does not connect directly to the internet, but to the Sunrise Gateway ("SBC").
The SIP trunk must be configured with "Media Relay", "exclusive G.711a" and "NO T.38".
Test Results
For more information on the test procedure, please read the following wiki article: Test Description V11 and later. Bold lines in the test results indicate a KO-criteria.
(*1) In special cases G.729 is supported, must be booked and enabled at Sunrise
(*2) Fax via G.711 (T.38 to G.711 / Audio Fax support) is supported by Sunrise and work in most scenarios.
(*3) While Sunrise do not offer a second ip address on the same port as the gateway, Sunrise offers a dual homing solution involving two SBCs configured on one account.
Basic Call
Tested feature | Result |
---|---|
call using g711a | OK |
call using g711u | OK |
call using g723 | NA |
call using g729 | OK (*1) |
call using g722 | NA |
Overlapped sending | NA |
early media channel outgoing | OK |
Fax using T.38 | NA |
T.38 Transcoding by the provider | NA |
Fax using G.711 | OK (*2) |
Reverse Media Negotiation | NOK |
CGPN can be suppressed | OK |
CLIP no screening | OK |
Long time call possible(>30 min) | OK |
External Transfer | OK |
NAT Detection | NA |
Redundancy | OK (*3) |
SIP over TCP | NA |
Voice Quality OK? | OK |
Direct Dial In
Tested feature | Result |
---|---|
Inbound(Provider -> Innovaphone) | OK |
Outbound(Innovaphone -> Provider) | OK |
Loop In call(Innovaphone -> Provider -> Innovaphone) | OK |
DTMF
Tested feature | Result |
---|---|
DTMF tones sent correctly via RTP-events(RFC 2833) | OK |
DTMF tones sent correctly via SIP-Info | OK |
DTMF tones received correctly via RTP-events(RFC 2833) | OK |
Hold/Retrieve
Tested feature | Result |
---|---|
Call can be put on hold | OK |
Held end hears music on hold / announcement from PBX | OK |
Transfer with consultation
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears music on hold | OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | OK | OK |
inno1 calls PSTN-phone. inno1 transfers to inno2. | OK | OK |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | OK | OK |
PSTN-phone calls inno1. inno1 transfers to inno2. | OK | OK |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | OK | OK |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | OK | OK |
Transfer with consultation (alerting only)
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears music on hold or dialling tone | OK |
Call returns to transferring device if the third
Endpoint is not available |
OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? | MoH Ok? |
---|---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | OK | OK |
inno1 calls PSTN-phone. inno1 transfers to inno2. | OK | OK |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | OK | OK |
PSTN-phone calls inno1. inno1 transfers to inno2. | OK | OK |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | OK | OK |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | OK | OK |
Blind Transfer
Tested feature | Result |
---|---|
Call can be transferred | OK |
Held end hears dialling tone | OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | OK |
inno1 calls PSTN-phone. inno1 transfers to inno2. | OK |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | OK |
PSTN-phone calls inno1. inno1 transfers to inno2. | OK |
PSTN-phone calls inno1. PSTN-phone transfers to inno2. | OK |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | OK |
CFU / CFB Transfer
Tested feature | Result |
---|---|
Call can be forward | OK |
Held end hears dialling tone | OK |
CFNR / Blind Transfer (alerting only)
Tested feature | Result |
---|---|
Call can be transferred or forward | OK |
Held end hears dialling tone | OK |
The following tests are made to test if call transfer is working.
Tested feature | Voice Ok? |
---|---|
inno1 calls inno2. inno2 transfers to PSTN-phone. | OK |
inno1 calls PSTN-phone. PSTN-phone transfers to inno2. | OK |
PSTN-phone calls inno1. inno1 transfers to inno2. | OK |
PSTN-phone calls inno1. inno1 transfers to other PSTN-phone-2. | OK |
Broadcast Group & Waiting Queue
Tested feature | Result |
---|---|
Caller can make a call to a Broadcast Group | OK |
Caller can make a call to a Waiting Queue | OK |
Announcement if nobody picks up the call | OK |
Configuration
Firmware version
All innovaphone devices use V11 build 11.3127 as firmware during test.
SIP - Trunk
Following configuration needs to be done in the SIP Gateway Interface settings:
- 1: Use "Gateway without Registration" as "Mode"
- 2: Enter the IP address of Sunrise SBC for "Remote Domain"
- 3: Enter the IP address of the innovaphone Gateway for "Local Domain"
- 4: Enter the IP address of Sunrise SBC for "Proxy"
- 5: Select G.711a as coder 20ms as Framsize and Exclusive
- 6: Disable "T.38", Enable Media-Relay" and No ICE"
- 7: Disable encryption
- 6: Use "Fixed AOR" in "From Header" and "CGPN in user part of URI" in "Identity Header"
Number Mapping
Following configuration needs to be done in the SIP Gateway Number Mappings:
- 1: Because Sunrise is using the full national number for incoming calls, you need to cut off the digits before an extension. In example, 04450199xx will be translated to xx.
Route Settings
A default Route Setup is used:
- 1: Force Enblock Setting is required for outgoing calls.
Fax
Sunrise does not support Fax communications with T.38. Because of this, T.38 can not be used.
If you want to use our Faxserver, you need to set T.38 to G.711 translation (Audio Fax support, available from V11). This works in a lot of cases where you have no problems with QoS.
Example to set T.38 to G.711 translation (Audio Fax support) on the Faxserver interface: