Howto:Analog Trunk (FXO) with Linksys SPA3102: Difference between revisions
(New page: '''Innovaphone Compatibility Test Report''' {{FIXME|reason=at work}} == Linksys (Sipura) SPA:3102 == Infomation: *Softwaere Version 3.3.6(GW) *Hardware version 1.3.5(a) ==innovapho...) |
(No difference)
|
Revision as of 18:49, 15 October 2007
Innovaphone Compatibility Test Report
|
FIXME: at work |
Linksys (Sipura) SPA:3102
Infomation:
- Softwaere Version 3.3.6(GW)
- Hardware version 1.3.5(a)
innovaphone gateway/pbx
This information applies to
- all PBX Platforms
6.00 dvl-sr2 IP800[07-60698]or higher
configuration
For connecting the Linksys for Analog Trunk ( FXO ) connection to the innovaphone Gateway/pbx you need a Gatekeeper/Registrar license.
Linksys configuration
Configuration of the proxy settings
Proxy: Ip address of the innovaphone Gateway/Pbx
user id: the registration name to the innovaphone Gateway/Pbx
Voip to PSTN gateway enable set to yes
Line Voip caller DP set to none
One stage dialing set to no
innovaphone configuration
Configure a registrar where the Linksys can register (as seen in picture below)
administration/gateway/voip
Configure a route to the Linksys
number out is here a 0 - you can take any digit this is for the analog trunk assignment.
Then you configure a " ^ " this indicates an Delay for one second , then the rest of the number will be dialed in dtmf with 300msec delay between every digit.
For incoming calls (from analog Trunk to innovaphone) you have to configure the proper routes - from the GW where the Sipura is connected to the pbx.
Supported Codecs
| Codec | Applies |
|---|---|
| G711 | yes |
| G729 | yes |
| G723 | yes |
| G726 | yes |
| GSM | no |
| T.38 UDP | no |
| G722 | No |
Test Results
Basic Call
| Tested feature | Result | |
|---|---|---|
| call using g711a | yes | |
| call using g711u | yes | |
| call using g723 | yes | |
| call using g729 | yes | |
| Overlapped sending | yes | |
| early media channel | not tetsed | |
| Fax | not tested | |
| Voice Quality OK? | yes |
Dial Inward
| Tested feature | Result | |
|---|---|---|
| Inbound(Sipura -> innovaphone) | yes | |
| Outbound(Innovaphone -> Sipura) | yes |
DTMF
| Tested feature | Result | |
|---|---|---|
| DTMF tones sent correctly | yes | |
| DTMF tones received correctly (audible) | yes |
Hold/Retrieve
| Tested feature | Result | |
|---|---|---|
| Device can put call on hold | yes | |
| Held end hears music on hold | yes | |
| Device can terminate either call and retrieve remaining call | yes |
Transfer with consultation
| Tested feature | Result | |
|---|---|---|
| Device can transfer call | yes | |
| Held end hears music on hold | yes | |
| Call returns to transferring device if the third
Endpoint is not available |
yes |
Transfer with consultation (alerting only)
| Tested feature | Result | |
|---|---|---|
| Device can transfer call | yes | |
| Held end hears music on hold or dialing tone | yes | |
| Call returns to transferring device if the third
Endpoint is not available |
yes |
Blind Transfer
| Tested feature | Result | |
|---|---|---|
| Device can transfer call | yes | |
| Held end hears dialing tone | no - hears nothing |
Broadcast Group & Waiting Queue
| Tested feature | Result | |
|---|---|---|
| Caller can make a call to a Broadcast Group | yes | |
| Caller can make a call to a Waiting Queue | yes | |
| Announcement if nobody picks up the call | yes |
Calling Party Number
| Tested feature | Result | |
|---|---|---|
| CGPN is displayed correctly | no | |
| CGPN can be supressed | yes |